Frigidaire FPSC2277RF Complete Owner s Guide - Page 29
Concern, Cause, Solution
View all Frigidaire FPSC2277RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
BEFORE YOU CALL CONCERN CAUSE SOLUTION AUTOMATIC ICE MAKER (Continued) Freezer ice • Ice maker wire signal arm • Move any item or frozen ice cubes that maker will not is being held down by a may block the signal arm from being in the stop making ice package in the freezer off or upward position. See Automatic Ice (select models). that has fallen against ice Maker-Freezer section in manual. maker. Ice cubes • Ice cubes are not being • Remove ice container and discard ice. The are freezing together. used frequently enough or interruption of power ice maker will produce fresh supply. Ice should be used at least twice weekly to for prolonged time. keep the cubes separated. • Ice cubes are hollow • This generally occurs when the ice maker (shells of ice with water does not get enough water. This is usually inside). The hollow cubes the result of a clogged water filter or break open in the bin restricted water supply. Replace the water and leak their water onto filter and if the condition still occurs check existing ice, which causes for a Saddle Valve, water valve not turned it to freeze together. on all the way or kinked water supply line. DISPENSER (Ice & Water) Dispenser will • Dispenser lock out is • Press and hold control lock for three not dispense ice. engaged. seconds. • There is no ice in the bin • See the "Ice maker is not making any ice" to be dispensed. section above. • The refrigerator doors are • Be sure the refrigerator doors are not completely closed. completely closed. Ice dispenser is jammed. • Dispenser paddle has been pressed too long and the dispenser motor has overheated. • Ice has melted and frozen around auger due to infrequent use, temperature fluctuations, and/or power outages. • The motor overload protector will reset in about three minutes and then ice can be dispensed. • Remove ice container, thaw, and empty the contents. Clean container, wipe dry, and replace in proper position. When new ice is made, dispenser should operate. Dispenser will not dispense water. • Ice cubes are jammed between ice maker and back of ice container. • Dispenser lock out is engaged. • Water filter not seated properly. • Remove ice cubes that are jamming the dispenser. • Press and hold control lock for three seconds. • Remove and reinstall the water filter. Be sure to push the filter firmly so that you hear it lock solidly into position. • Water filter is clogged. • Replace filter cartridge. Be sure to remove protective caps and push the filter firmly so that you hear it lock solidly into position. • Household water line valve is not open. • Open household water line valve. See CONCERN column AUTOMATIC ICE MAKER. 29