Frigidaire FPSC2278UF Complete Owners Guide - Page 35

BEFORE YOU CALL 1-800-374-4432 (United States) 1-800-265-8352 (Canada) CONCERN CAUSE AUTOMATIC ICE MAKER Ice maker is not • Ice maker is turned off. making any ice. • Refrigerator is not connected to water line or water valve is not open. • The water supply line is kinked. • The water filter is not seated properly. Visit our web site at www.frigidaire.com SOLUTION • Turn on ice maker. Press and hold the "ONOFF" button on the display panel for three seconds until the indicator light turns on. (Some Models) Move wire signal arm to the "down" position on the ice maker. • Connect the unit to the household water supply and ensure the water valve is open. • Ensure that the supply line does not kink when the refrigerator is pushed into place against the wall. • For Frigidaire Gallery, remove and re-install the water filter. Be sure to push the filter firmly so that you hear it lock solidly into position. For Frigidaire Professional, remove and re-install the water filter. Remove by rotating it counter-clockwise (to the left) 90 degrees to release it. Re-install by sliding it into the filter housing as far as it will go with the grip end horizontal. Push lightly inward on the filter while rotating it clockwise (to the right). The filter will then pull itself inward as it is rotated. Rotate the filter 90 degrees until it stops and the grip end is vertical. You may be able to feel a very light click as the filter locks into place. • The water filter may be clogged with foreign material. • If water dispenses slowly or not at all, or if the filter is six months old or older, it should be replaced. • Freezer ice maker wire • Move any item or frozen ice cubes that signal arm is being held may block the signal arm from being in the up by an item not allowing on or down position. See Automatic Ice it to go in the on or down Maker-Freezer section in manual. position. (Does not apply to Frigidaire Professional) 35