Frigidaire FRA053PU1 Complete Owner's Guide (English) - Page 10
continued, DRAINAGE
UPC - 012505275791
View all Frigidaire FRA053PU1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Operating Instructions Operating Instructions (continued) SWING OPERATION: CHECK FILTER FEATURE: FAULT CODE: When you turn on the unit, the louver will swing and stop at a certain angle. You can press the SWING button to let the louver swing automatically. Press the SWING button again while you want the louver stop at desired angle. This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) which above the "Filter" button will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Filter" button and the light will go off. If the display reads "EA" , the room temperature sensor has failed. Contact your Authorized Frigidaire Service Center. If the display reads "ES" , the evaporator temperature sensor has failed. Contact your Authorized Frigidaire Service Center. If the display reads "E4" , the display panel communication has failed. Contact your Authorized Frigidaire Service Center. If the display reads "P1" , bottom tray is full. Carefully move the unit to a drain location, remove the bottom drain plug and let the water drain away. Restart the machine until the "P1" symbol disappears. If error repeats, call for service. DRAINAGE: During the dehumidifying mode, you will need a garden hose (sold separately) to drain the condensate from the unit. Remove the rubber stopper from the hose connector, then screw on a garden hose to the connector as shown on fig 23. The hose may then: A. Discharge into a drain that is lower than the unit. B. Be connected to a condensate pump (sold separately). Garden hose Remove the supplied rubber stopper Fig. 23 10 2009 Electrolux Home Products, Inc. All rights reserved.