Frigidaire FRA106HT2 Installation Instructions (All Languages) - Page 12
White Westinghouse or Frigidaire
UPC - 012505274039
View all Frigidaire FRA106HT2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installation Instructions Wall Sleeve Brands: #9 White Westinghouse or Frigidaire 22" Deep 1. Remove existing rear grille as shown on Page 3 of this manual and replace with provided louvered rear panel. Install as shown here. NOTE: You may need to drill holes in flange of existing sleeve to match 80º new rear grille Because of the increased unit depth, first try dry fitting using the method described below: 2. Place (2) 1" x 11 2" x 14" seals against each side. 3. Gently slide unit in and check if amount extending from the sleeve is sufficient once the trim frame is attached. 4. If position is okay, remove unit and Proceed to the next step.If not go to step 8. 5. Attach (1) 1" x 11 2 " x 15" seal to the left and right sides of the sleeve. 6. Cut (1) 1" x 11 2" x 25" long seal to 14" long and attach it vertically to the rear grill 3.5" from the left side. Repeat and attach 3" from the right side. 7. Attach (1) 1" x 11 2" x 25" long seal in the center at the top of the sleeve. Remove the backing paper and press into position. Proceed to step 14. Use these next steps if the unit requires extra extension into the room. 8. Attach 1" x 3 4 " x 14" long seal over the solid vertical portion of the rear grille. 9. Attach (2) 4 3 4" x 3 3 4" x 13 4 " foam blocks with the slot overlapping the seal above. 10. Install the divider into the slots of the foam blocks. You may need to trim the length to size. 11. Repeat steps 8-10 for the other vertical shown portion of the grille as shown in the picture. 12. Attach (2) 1" x 11 2 " x 14" seals along the sides of the sleeve again making sure all seals are flush. 13. Cut the 1" x 11 2" x 25" seal to fit the top of the sleeve. The pieces must be fitted flush to the edge of the divider. 14. Center unit & gently slide unit into sleeve. 15. Before sliding all-the-way back, remove 2nd screw from front on left side of unit. 16. Remove the plastic washer from the screw. 17. Screw and attach the other end of the ground wire from sleeve to the unit as shown in picture. Make sure that the toothed washer is against the cabinet. 18. Slide the unit completely to the rear to ensure a good seal, making sure the ground wire does not become tangled. 19. Seal & Frame the unit as described on the last page of these instructions. 20. If you have difficulty with mounting the grill to the sleeve, follow the instructions for direct mounting on Page 13. 12 Rear Louvers 50º 50º 80º Top View