Frigidaire FTF2140FS Installation Instructions - Page 4

LOCATION OF YOUR WASHER DO NOTINSTALL YOUR WASHER: 1. In an area exposed to dripping water or outside weather conditions. The ambient temperature should never be below 60 ° F (15.6 ° C) for proper washer (detergent breakdown) operation. 2. In an area where it will come in contact with curtains or drapes. 3. In an area (garage or garage-type building) where gasoline of other flammables are kept or stored (including automobiles). 4. On carpet. Floor MUST be solid with a maximum slope of 1/2 in. per foot (I .27 cm per 30.5 cm). To ensure vibration or movement does not occur, reinforcement of the floor may be necessary. IMPORTANT MINIMUM INSTALLATION CLEARANCES When installed in alcove or closet: Sides, Rear = 0 in. (0 cm) Top = 0 in. (0 cm) When installed in closet: Front = I in. (2.54 cm) Closet door ventilation required: 2 Iouvered openings each 60 in2(387 cm2), 3 in. (7.6 cm) from top and bottom of door. 4. Carefully return the washer to an upright position. 5. Carefully move the washer to within 4 feet (122cm) of the final location. 6. Remove the following from the back panel of the washer: 4 shipping bolts, 4 spacers, 1 metal "P" clamp. 7. Remove the 4 plugs from the literature pack located in the drum and install them in the holes vacated by the packaging spacers. NOTE: If the washer is to be transported at a later date, the shipping support hardware must be reinstalled to prevent shipping damage. UNPACKING 1. Cut the shipping carton along the dotted line along the bottom. Remove the carton. 2. Using a rug, blanket or piece of cardboard to protect the floor, lay the washer on it's back. 3. Remove and save the styrofoam base and shipping plug. Remove: metal "P" clamp Shoping Base Plug 4 shipping _olts, 4 spacers.