Frigidaire FTF530FS Wiring Diagram (All Languages) - Page 2

! WARNING This information is intended for use by persons having electrical and mechanical training and a level of knowledge of these subjects generally considered acceptable in the appliance repair trade. The manufacturer or seller can not be responsible, nor assume any liability, for injury or damage of any kind arising from the use of this data. L1 DOOR LAMP WON'T LIGHT OR DOOR LOCK SOLENOID WON'T ENERGIZE 0T 0C TIMER 4.4 2.1 DOOR LOCK COIL N L1 IF NO MOTOR ROTATION DURING FILL OR AGITATION (PHASE 1) 3 N C6.6 C6.5 (AC) (AC) C6.1 (P1) (PHASE 2) 2 C6.2 (P2) 2 1 DOOR LAMP (PHASE 3) 1 (TACH) 5 C6.3 (P3) C10.3 (T2) IF NO END-OF-CYCLE SIGNAL (BUZZER) 0T 0C TIMER 2.2 4.3 DOOR LOCK IF DOOR LOCK OPENS DURING SPIN 0T 0C TIMER 2.2 4.3 DOOR LOCK IF TIMER WON'T ADVANCE 0T 0C TIMER 2.2 4.3 DOOR LOCK 12C TIMER 12C 12B TIMER CYCLE SIGNAL SWITCH 12C 12T TIMER 14C 14B TIMER CYCLE SIGNAL MS TIMER MOTOR 6C 6T TIMER PTC +t WAX MOTOR C10.5 C6.5 SPEED CONTROL 0T 0C TIMER (TACH) 6 (GND) 4 2.2 4.3 DOOR LOCK 1 3 2 WATER LEVEL SWITCH TIMER CONTACTS 1, 3, 5 AND 7: REFER TO TIMER CHART FOR THE MOTOR CONTROL CODE AND MACHINE FUNCTION. MOTOR 12T TIMER 14C TIMER * TIMER CONTACTS SHOWN AT THE START OF THE REGULAR WASH CYCLE. * 1C * 3C * 5C * 7C 1B TIMER 3B TIMER 5B TIMER 7B TIMER C10.4 (T1) C6.4 (GND) C10.2 (A) C10.1 (B) C10.6 (C) C10.10 (D) SPEED CONTROL IF WATER PUMP DOES NOT WORK 0T 0C TIMER 2.2 4.3 DOOR LOCK IF WATER PUMP DOES NOT WORK IN EXTRA RINSE 0T 0C TIMER 2.2 4.3 DOOR LOCK 12C 12T TIMER 14C 14B TIMER 12C 12T TIMER 14C 14T TIMER 1 2 EXTRA RINSE M 1 2 PUMP MOTOR M 1 2 PUMP MOTOR IF NO MOTOR ROTATION DURING SPIN 0T 0C TIMER 2.2 4.3 DOOR LOCK WATER LEVEL SWITCH 3 1 2 2C TIMER 4C 4T TIMER 4.2 4.1 WAX MOTOR C10.9 (E) IF NO HOT, WARM OR COLD WATER DURING WASH FILL (DETERGENT) 1 3 0T 0C TIMER 2.2 4.3 DOOR LOCK 2 WATER LEVEL SWITCH 2C TIMER 4C TIMER IF NO COLD WATER DURING RINSE FILL (BLEACH) 1 3 0T 0C TIMER 2.2 4.3 DOOR LOCK 2 WATER LEVEL SWITCH 2C 2B TIMER 4C TIMER 8C 8T TIMER 10C 10B TIMER 5 1 TEMP SWITCH 8C 8B TIMER 2 4 TEMP SWITCH HOT WATER SOLENOID 8B TIMER COLD WATER SOLENOID COLD WATER SOLENOID BLEACH SOLENOID IF NO WARM OR COLD WATER DURING RINSE FILL (SOFTENER) 1 3 0T 0C TIMER 2.2 4.3 DOOR LOCK 2 WATER LEVEL SWITCH 2C TIMER COLD WATER SOLENOID 8C 8B TIMER 1 3 TEMP SWITCH 10T 10C TIMER 2 4 TEMP SWITCH HOT WATER SOLENOID 4C 4B TIMER SOFTENER SOLENOID BLEACH SOLENOID 12C 12T TIMER (PHASE 1) 3 (PHASE 2) 2 (PHASE 3) 1 (TACH) 5 (TACH) 6 (GND) 4 MOTOR 14C TIMER 1C 1B TIMER 3C 3B TIMER 5C 5B TIMER 7C 7B TIMER C6.6 C6.5 (AC) (AC) C6.1 (P1) C6.2 (P2) C6.3 (P3) C10.3 (T2) C10.4 (T1) C6.4 (GND) C10.2 (A) C10.1 (B) C10.6 (C) C10.10 (D) SPEED CONTROL NOTE: BOLD LINES INDICATE INTERNAL TIMER JUMPER WIRES. DASHED LINES INDICATE CIRCUITS NOT ON ALL MODELS. IMPORTANT If grounding wires, screws or clips used to complete a path to ground are removed for service, they must be returned to their original position and properly fastened. Certain internal parts are intentionally NOT grounded and may present a risk of electric shock only during servicing. Do not contact the following parts while the appliance is energized: pump, drive motor and electronic control boards. DIAGNOSTIC STRIP CIRCUITS PART NO. 134968300 A