Frigidaire GAH085Q1T Installation Instructions - Page 4
Fedders
UPC - 012505272547
View all Frigidaire GAH085Q1T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Wall Sleeve Brands: #2 Fedders 19 ¾ Deep 7" 60o Rear Louvers 1. Redirect the louvers at the back of the wall sleeve as shown opposite. The use of pliers is recommended. 60o Top View k7m 6 7 2 3 5 2. Attach (2) 4 ½" x 3 ½" x 1 ½" centering/support blocks one on each side wall. Place in center of side wall with the tapered end facing the opening. 3. Cut (2) 17" Tapered Spacer Blocks as shown below into two pieces. 17". 2 1" 3/4" Tapered Spacer Block Cut Here 4" Protection Paper Backing 4. The 4" section is placed in front of the rib on base with the tapered end facing the back of the sleeve. The remaining portion will be placed behind the rib again sloping toward the rear of the sleeve. This helps induce a rearward slope on the unit. 5. Attach (1) 1 ½" x 3/8" x 25" long seal in the center at the top of the sleeve. Remove the backing paper and press into position. 6. Attach (2) 1 ½" x 3/8" x 14" seals to the left and right sides of the sleeve. 7. Cut the 1 ½" x 3/8" x 25" long seal to 14" long and attach it to the vertical section of the rear grille as shown. 8. Gently slide unit into sleeve. 9. Before sliding all-the-way back, remove 2nd screw from front on left side of unit. 10. Remove the plastic washer from the screw. 11. Screw and attach the other end of the ground wire to the unit as shown in picture. Make sure that the toothed washer is against the cabinet. 12. Slide the unit completely to the rear to ensure a good seal, making sure the ground wire does not become tangled. 13. Seal & Frame the unit as described on the last page of these instructions. 4