Frigidaire GLEH1642FS Installation Instructions (All Languages) - Page 7
Warning - laundry center
UPC - 012505376368
View all Frigidaire GLEH1642FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
MOBILE HOME INSTALLATION UNPACKING 1. Dryer MUST be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4 inches (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. 1. Using the four shipping carton corner posts (two on each side), carefully lay the laundry center on its left side and remove the foam shipping base. C AUT ION Excessive weight. Use two or more move Laundry Center. people to 2. If dryer is exhausted through the floor and area beneath the mobile home is enclosed, the exhaust system MUST terminate outside the enclosure with the termination securely fastened to the mobile home structure. SHIPPING CARTON CORNER POSTS FOAM SHIPPING PAD 3. Refer to page 3 for other important venting requirements. 4. When installing a gas dryer into a mobile home, a provision must be made for outside make up air. This provision is to be not less than twice the area of thedryer exhaust outlet. 5. Installation MUST conform to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or when such standard is not applicable, with American National Standard for Mobile Homes. In Canada, the CSA Z240 is applicable. WARNING The laundry center is designed under ANSI Z 21.5.1 for HOME USE only. 2. Return laundry center to an upright position. 3. Remove the following from the back side of the washer: 4 bolts, 4 yellow plastic spacers, 3 metal "P" clamps. 4. Remove the service panel from the front of the washer. 5. Remove the 4 nuts and 6 large washers that attach the 2 yellow shipping braces to the drum and the base. Lift up on the drum and remove the braces (a yellow ribbon surrounds the items to be removed). 3 6. Remove the large styrofoam block located 3 under the drum. Lift up on the drum, tilt the base of the foam block inwards toward the rear of the washer until free, then pull it out. 7. Remove and discard the yellow ribbon and label from the front of the washer. 8. Replace the service panel and screws. 9. Carefully move the laundry center to within 4 feet (1.22m) of the final location to begin the installation. NOTE: If the laundry 5 center is to be transported at a later date, the shipping support hardware must be reinstalled to prevent shipping damage. 4 BOLT SPACER "P" CLAMP 8 7 5 6