Frigidaire GLGC36S9EQ Use and Care Manual - Page 6
Before Setting Surface Controls
View all Frigidaire GLGC36S9EQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Before Setting Surface Controls Assembly of the Surface Burner Heads, Burner Caps and Burner Grates (Porcelain & Stainless Steel Cooktop models) It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates are installed correctly and at the correct locations. 1. Remove all packing tape from cooktop area. Remove all Burner Caps and Burner Heads. 2. Discard all packing material located under Burner Heads (if applicable). 3. To replace the Burner Heads & Caps, match the letters located under center of Burner Caps with the letters located inside Burner Heads (Figure 1). 4. Match Burner Skirts (some models) or the emboss on the cooktop with Burner Heads and Burner Caps (see Figure 1). Replace the Burner Heads and Caps on cooktop (see Figure 2). Carefully align the Electrodes into slot or hole of each Burner Head (Figure 3). Note: The Burner Heads should sit flat on Cooktop Burner Skirts. 5. Unpack Burner Grates and position on the cooktop. REMEMBER - DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use. Electrodes must align into slot or hole for each Burner Head. Figure 2 (some models) Figure 1 Assembly of the Surface Burner Heads, Burner Caps and Burner Grates (Ceramic Glass Cooktop models) It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates are installed correctly and at the correct locations. 1. Be sure to follow the Installation Instructions before installing and using your new cooktop. 2. Remove all packing tape from cooktop. Remove Burner Caps and Burner Heads (See Figure 3). Electrodes must align into slot or hole for each Burner Head. 3. Discard all packing material located under all Burner Heads (if Figure 4 applicable). 4. To replace Burner Heads & Caps, match the letters located under center of Burner Caps with the letters located inside Burner Head (See Figure 5). Place all Burner Heads & Caps Grate Pin on the cooktop while carefully aligning the Electrodes into slots or holes of the Burner Heads (Figure 4). Note: The Burner Heads should sit flat on Cooktop Burner Skirts. Burner Cap Pilot hole 5. Unpack Burner Grates. NOTE: Do not force End Burner Figure 5 Figure 3 Grates down on cooktop. Be careful to line up the 2 Grate Pins located on each of the 2 End Burner Grates into the Pilot holes located on top of the Burner Caps (See Figure 5). Position Burner Grates on cooktop and check that all the Burner Grate legs lie on the glass surface. REMEMBER - DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use. 6