Frigidaire GLGT1031CS Operating Instructions - Page 1

WASHER OPERATING INSTRUCTIONS WASH/RINSE TEMPERATURE WARM WARM • HOT COLD • COLD COLD WARM • COLD LOAD SIZE (WATER LEVEL) MEDIUM SMALL (LDWJ • • LARGE (FULL) • • RESET * * SOME MODELS SOAK/ PREWASH PREWASH 1.5 12 • 4 REGULAR/WHITES SO FINAL SPIN RINSE KNITS/ DELICATES RINSE FINAL SPIN e 4 • 12 es NSE 6 FINAL PIN PERM PRESS/COLORS VersiOn en espariol Si desea obtener una copia en espanol de estas Instrucciones de Funcionamiento, sir-vase escribir la direccion que se incluye a continuaciOn. Solicite la P/N 131921400. Spanish Owner's Guides Frigidaire Home Products P. 0. Box 212378 Augusta, GA30917 Before Operating Your Laundry Center Read your laundry center Owner's Guide. It has important safety and warranty information. It also has many suggestions for obtaining the best washing results. aWARNING To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS in your laundry center Owner's Guide before operating this appliance. Operating Steps 1. Sort laundry into loads that can be washed together. 2. Prepare items for washing. 3. Pretreat stains and heavy soil. 4. Add the measured amount of detergent to the washer before adding the laundry load. 5. If desired, add liquid bleach to the Bleach Dispenser. 6. Add the laundry load to the wash tub. 7. If desired, add liquid fabric softener to the Fabric Softener Dispenser on some models or during the final rinse. 8. Set washer controls according to type, size, and soil level of the load: • Wash/Rinse Temperature •Load Size/Water Level Control Settings Chart for suggested cycle settings. 10. Start the washer by closing the lid and pulling out the cycle selector knob. The washer will operate with the lid open; however, the tub will not spin unless the lid is closed. To stop the washer, push in the cycle selector knob. To change' a cycle, push in the cycle selector knob and turn it clockwise to the desired setting. Pull out the knob to restart the washer. 11. Remove items when the cycle is completed. As a safety measure, the lid will AUTOMATICALLY LOCK during the spin portion of each cycle. The lid will automatically unlock approximately 1 minute after the end of the spin cycle. Cycle Selection For best results, follow the fabric care label directions on items to be washed. Check the Control Settings Chart (reverse side) if the care label is not available. 9. Push in the cycle selector knob and turn it The Regular, Perm Press and Knits / Delicates cycles clockwise to the desired wash cycle. See provide a spray rinse during the first spin, followed by Cycle Selection for cycle descriptions and a deep rinse and a final spin. Printed in U. S. A. (continued, reverse side) P/N 131921300 (9912)