Frigidaire GLHS69EJPB Installation Instructions (All Languages) - Page 1
Frigidaire GLHS69EJPB - 26 cu. Ft. Refrigerator Manual
View all Frigidaire GLHS69EJPB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
TO BE REMOVED BY THE CUSTOMER AFTER INSTALLATION IS COMPLETE INSTALLATION CHECKOFF LIST Doors Handles are secure and tight Door seals completely to cabinet on all sides Freezer door is level across the top Leveling Refrigerator is level, side to side and tilted 1/4" (6mm) front to back Toe grille is properly attached to refrigerator Cabinet is setting solid on all corners Electrical Power House power turned on Refrigerator plugged in Ice Maker House water supply connected to refrigerator No water leaks present at all connections - recheck in 24 hours Ice Maker is turned ON. Ice & Water Dispenser operates correctly Front filter must be flush with filter housing (some models) Final Checks Shipping material removed Fresh Food and Freezer controls set Crisper Humidity controls set Registration Card sent in Refer to your Owner's Use and Care Manual for additional information about your refrigerator. 5 LEVELING AND ADJUSTING All four corners of refrigerator must rest firmly on a solid floor. Your refrigerator has adjustable rollers to help level it and to adjust the doors. To level cabinet or change door height: 1. Remove toe grille. 2. Use a screwdriver, 3/8" wrench, or nutdriver to adjust the rollers. To raise cabinet or door, turn screw clockwise. To lower cabinet or door, turn screw counterclockwise. Toe Grille 6 Adjustable Front Roller (some models) CONTROLS 1 HAND TRUCKING • Load refrigerator from side of cabinet only. • Do not run retaining straps over handles. • Do not over-tighten retaining straps. • Never use refrigerator handles to move the refrigerator. • Remove tape from doors only after unit is in place. 2 1 PIECE OF FOAM OR CARDBOARD 2 WIRE TIES (All wire baskets will have 2 wire ties) SHIPPING MATERIAL 1 PIECE OF TAPE 1 PIECE OF TAPE OR 2 BLUE SHIPPING CLIPS 1 PIECE OF TAPE SHELF SPACER WITH TOE GRILLE 1 PIECE OF TAPE 3 PIECES OF TAPE 1 PIECE OF TAPE Remove Shipping material. (Features may vary per model.) 3 Plastic Water Tubing to Ice Maker Fill Tube WATER SUPPLY Steel Clamp Brass Compression Nut Connect water supply - check for water leaks. Turn icemaker OFF if water supply is not connected immediately. Connecting to a reverse osmosis system is not recommended. When changing control settings, wait 24 hours before making additional adjustments. 7 ICEMAKER OR ON OFF Wire Signal Arm OFF ON Ensure icemaker to turned ON. Check to see that the Ice & Water Dispenser is operating correctly. (See Automatic Ice & Water Dispenser Features in Use & Care Manual.) 8 TO REMOVE DOORS (if necessary) Copper water line from household water supply (Include enough tubing in loop to allow moving refrigerator out for cleaning.) q L K e äáåÉ t K WATER SUPPLY 4 INSTALLATION CLEARANCES Allow the following clearances for ease of installation, proper air circulation, and plumbing and electrical connections: • Sides & Top..........3/8" • Back 1" NOTE If you are installing your refrigerator beside a wall, leave 1/2" minimum between hinges and wall to allow for the door to swing open. If you need to remove the doors to get your refrigerator in the house, please See Door Removal Instructions in your Use & Care Manual. 9 √ See "Normal Operating Sights & Sounds" in the Use & Care Manual so you understand the sounds you may hear once your refrigerator is running. √ Please read entire Use & Care Manual to become aware of important safety instructions and to become familiar with your new refrigerator. √ Send in Registration card to register your refrigerator. √ Congratulations! You are ready to enjoy your new refrigerator. IF YOU ARE DISSATISFIED WITH THE INSTALLATION, PLEASE CALL THE STORE YOU PURCHASED IT FROM. P/N: 241811501