Frigidaire PLBMV188HC User Manual - Page 26

CLEANING AND CARE Disconnect the power cord before cleaning or leave the door open to deactivate the oven during cleaning. CHARCOAL FILTERS Charcoal Filters, which are attached with Hood Louver, are used for nonvented, recirculated installation. The filter should be changed every 6 to 12 months depending on use. 1. Disconnect power to the microwave oven at the circuit breaker panel or by unplugging. 2. Remove three Houver Louver Screws. 3. Push the upper tabs and pull the louver away from the unit. 4. Remove the charcoal filters from hood louver and replace new charcoal filters by piercing tabs into the holes in charcoal filters. 5. Carefully push the louver back into place and replace the screws removed at step 2. Oven Light Cover Hood Louver Screws MICROWAVE OVEN LIGHT Remove the louver per instructions 1-3 above, if used. 1. To replace an old light bulb, first disconnect power to the microwave oven at the circuit breaker panel or by unplugging. 2. Open oven light cover by carefully pulling up on the front edge. See figure 1. 3. Remove an old light bulb and replace a new 20 watts light bulb. DO NOT USE BULB LARGER THAN 20 WATTS. 4. Close the Oven Light Cover by carefully pushing into place. Push the louver back into place (engaging both the bottom and top tabs) and replace three Houver Louver Screws. WORK/NIGHT LIGHT 1. To replace old light bulbs, first disconnect power to the microwave oven at the circuit breaker panel or by unplugging. 2. To open Light Cover, remove the screw on the light cover. (See Figure 3.) 3. Replace the old light bulbs with new bulbs. DO NOT USE BULBS LARGER THAN 20 WATTS. 4. Close the Light Cover and secure with screw removed at step 2. BOTTOM VIEW Light Bulbs (Front of microwave oven) Figure 1 Hood Louver Upper Tab Bottom Tab Inside of Hood Louver Charcoal Filters Figure 3 (Rear of microwave oven) Light Cover Screw Light Cover may become very hot. Do not press glass when light is on. Tabs Figure 2 E 26