Frigidaire PLEB27M9EC Installation Instructions - Page 4
Cabinet Installation - instructions
UPC - 057112090344
View all Frigidaire PLEB27M9EC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
MICROWAVE/ WALL OVEN COMBINATION INSTALLATION INSTRUCTIONS If oven is used in a new branch circuit installation (1996 NEC), mobile home, recreational vehicle, or where local codes DO NOT permit grounding through the neutral (white) wire (see figure 3): 1. Disconnect the power supply. 2. Separate the green (or bare copper) and white appliance cable wires. 3. In the circuit breaker, fuse box or junction box: connect appliance and power supply cable wires as shown in Figure 3. Cable from Power Supply Ground Wire Red Wires White Wire Ground Wire (Bare or Green Wire) Junction Box Black Wires White Wire U.L.-Listed Conduit Connector (or CSA listed) Cable from appliance Figure 3 4-WIRE GROUNDED JUNCTION BOX DO NOT ground to a gas supply pipe. DO NOT connect to electrical power supply until appliance is permanently grounded. Connect the ground wire before turning on the power (Figure 3). If connecting to a 4-wire electrical system (mobile homes), the appliance frame MUST NOT be connected to the neutral wire of the 4-wire electrical system. NOTE TO ELECTRICIAN: The armored cable leads supplied with the appliance are UL-recognized for connection to larger gauge household wiring. The insulation of the leads is rated at temperatures much higher than temperature rating of household wiring. The current carrying capacity of the conductor is governed by the temperature rating of the insulation around the wire, rather than the wire gauge alone. Heavy Weight Hazard • Use 2 or more people to move and install this combination oven. • Failure to follow this instruction can result in injury or damage to the unit. 4. Cabinet Installation The combination oven can tip when the door is open. The mounting brackets supplied with the oven must be attached to the cabinet and the appliance to prevent tipping of the wall oven and injury to persons. Mounting Brackets Installation Instructions 1. Unpack the wall oven. Remove the bottom trim taped on the oven side panel. Find the 2 mounting brackets and screws included in the literature package. 2. Install the mounting bracket in the wall cabinet as shown in Figure 4. Note: To prevent damage to cabinet, it is recommended to drill 1/16" (0.16 cm) dia. pilot holes before installing the mounting brackets. F Mounting Brackets H 22 3/16" * (56.4 cm) * If wood spacers are needded (see figure1 ) please calculate this dimension from the top of the spacer to the middle of the mounting bracket. Figure 4 3.Insert the oven into the cabinet opening. Slide oven inward leaving 1½" (3.8 cm) clearance between the oven and front of cabinet (see Figure 5). Pull the armored cable through the hole for it in the cabinet and toward the junction box while moving the appliance inward. 4