Fujitsu DL3700 User Manual - Page 32
SE7T1NG, Installing, ribbon, cartridge
View all Fujitsu DL3700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
SE7T1NG UP 2-10 4. Locate the two ribbon release levers on either side of the ribbon cartridge. Each ribbon rele SP lever has a mounting pin on the side. As shown below, place the mounting pins on the ribbon support bracket of the head carrier. Insert the ribbon so that the ribbon falls between the nose of the print head and the plastic print guide. Print head Head carrier Print guide 4 Installing the ribbon cartridge 5. Press the ribbon release levers inward until the mounting pins snap into the holes of the ribbon support brackets. Gently pull on the cartridge to be sure that the pins are secure in the holes. 6. Turn the ribbon feed knob clockwise to take up any slack in the ribbon. 7. Move the paper thickness lever back to position 1, which is the correct setting for printing most single sheets. 8. Close the front cover. NOTE A Fujitsu ribbon cassette is recommended. Dont't use other cassf.,4400, If other cassettes are used, operating problems or damage of print head may be caused. User's Manual