Fujitsu FI5650C Operator's Guide - Page 133
Double-feed detection
View all Fujitsu FI5650C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
Introduction CONTENTS 1 NAMES AND FUNCTIONS OF PARTS 2 BASIC SCANNER OPERATION 3 SCANNING VARIOUS TYPES OF DOCUMENTS 4 DAILY CARE 5 REPLACING CONSUMABLES 6 TROUBLESHOOTING 7 ONLINE SETUP 7.1 Online setup 7.2 Double-feed detection 7.3 Setting of Page Edge Filler 7.4 Setting dropout color 7.5 Setting of pre-pick mode 7.6 Resetting the consumables counters 7.7 Adjusting the offset 7.8 Adjust the magnification 7.9 Power saving 8 DOCUMENT SPECIFICATION OF ADF 9 OPTIONS 10 SCANNER SPECIFICATIONS Appendix 7.2 Double-feed detection The settings for the double feed detection are as follows. 1. Select [All Programs] - [Scanner Utility for Microsoft Windows] from [Start] menu then click [FUJITSU Software Operation Panel]. 2. Click [Device Setting 2] tab, then select [DoubleFeed] from [Preferences]. 3. When you select [Check Length] or [Check overlapping and length], select [Length] from 10, 15 or 20mm. None : The double feed detection will not be performed. Check Length : The documents length will be monitored. Check Overlapping : Document overlapping will be monitored. Check overlapping and length: The document length (you can select error detection tolerance from 10, 15 or 20mm) and overlapping will be monitored. If the detected length deviation is within the specified tolerance, it will not be detected as an error. ATTENTION Change the double feed configure of the FUJITSU TWAIN32 Scanner driver before you change the double feed configure in the [Software Operation Panel]. It will take precedence FUJITSU TWAIN32 Scanner driver. All Rights Reserved, Copyright (C) PFU LIMITED 2004