Fujitsu MHM2150AT Manual/User Guide - Page 85
Command block registers
View all Fujitsu MHM2150AT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Interface 5.2.2 Command block registers (1) Data register (X'1F0') The Data register is a 16-bit register for data block transfer between the device and the host system. Data transfer mode is PIO or DMA mode. (2) Error register (X'1F1') The Error register indicates the status of the command executed by the device. The contents of this register are valid when the ERR bit of the Status register is 1. This register contains a diagnostic code after power is turned on, a reset , or the EXECUTIVE DEVICE DIAGNOSTIC command is executed. [Status at the completion of command execution other than diagnostic command] Bit 7 ICRC Bit 6 UNC Bit 5 X Bit 4 IDNF Bit 3 X Bit 2 Bit 1 Bit 0 ABRT TK0NF AMNF X: Unused - Bit 7: - Bit 6: - Bit 5: - Bit 4: - Bit 3: - Bit 2: - Bit 1: - Bit 0: Interface CRC Error (ICRC). This bit indicates that a CRC error occurred during Ultra DMA transfer. Uncorrectable Data Error (UNC). This bit indicates that an uncorrectable data error has been encountered. Unused ID Not Found (IDNF). This bit indicates an error except for bad sector, uncorrectable error and SB not found. Unused Aborted Command (ABRT). This bit indicates that the requested command was aborted due to a device status error (e.g. Not Ready, Write Fault) or the command code was invalid. Track 0 Not Found (TK0NF). This bit indicates that track 0 was not found during RECALIBRATE command execution. Address Mark Not Found (AMNF). This bit indicates that the SB Not Found error occurred. 5-8 C141-E104-03EN