Fujitsu XG2600 Quick Start Guide - Page 2

6. The following command line examples are recommended for initial setup. Enter the commands as shown . Insert the local site values required as indicated within the "< >" brackets. Additional details to these commands and other configuration options can be found in Chapter 4 and 5 of the XG User's Guide (CD-ROM). # After login: configure # This command prompts for a password password admin set # Switch name sysname # Set up the switch for in-band OR out-of-band # management # In-band management port and default vlan lan 0 ip address 3 lan 0 vlan 1 # Out-of-band management port oob ip address 3 # Set date, time, and time zone offset from GMT. # For example, the Pacific Standard Time zone # offset is -0800. date YYYY/MM/DD.hh:mm:ss time zone # always commit and save configuration changes commit save # must reset switch for hostname to take affect. # This command prompts for a y/n reply. reset 7. When the Ready LED stops blinking , unplug the AC power cords. The switch is ready for deployment. 8. If rack mounting the XG2600, please carefully review the Safety Precautions and Notes on Use sections of the Hardware Guide before attempting installation. Rack mounting the XG2600 is a two-man operation. Complete installation per the Hardware Guide Instructions . CAUTION: Im proper handling m ay cause personal injury or dam age to the device and/or property. 9. If rack mounting the XG2600 for other than the default mounting (port side to the rear of the rack ), please carefully review the instructions detailed in section 1.1.2 Installation of Switch: Front Access or Rear Access (User Configured Airflow ) and complete reconfiguration of the hardware before rack mounting the switch . CAUTION: Im proper configutation m ay cause dam age to the device and/or property. 10. Stepping through the preceding instructions completes installation of the XG2600. Thank you for selecting Fujitsu as your 10 Gigabit Ethernet switch provider. Additional accessories are available from Fujitsu to expand networking attachments to the XG2600: Direct-Attach (Twinax) passive cables: SFPP-CBL-01 SFPP-CBL-02 SFPP-CBL-03 SFPP-CBL-05 SFPP-CBL-07 1 m eter, push or pull tab 2 m eter, push or pull tab 3 m eter, push or pull tab 5 m eter, push or pull tab 7 m eter, push or pull tab Optical Transceivers: SFPP-SR SFPP-LR 10G BASE-SX, M ultim ode, 850 nm 10G BASE-LX, Single-m ode, 1310 nm