Garmin 010-11018-00 Quick Start Manual (with 10x) - Page 4

➊ Install the Battery 1. Locate the black or gray lithium-ion battery that came in the product box. 2. With your thumbnail, slide the battery cover release tab toward the end of the GPS 10x. 3. Pull the battery cover off. 4. Locate the metal contacts on the end of the battery. Insert the battery so the metal contacts on the battery match up with the ontacts inside the battery compartment. Press the battery down into place. 5. Replace the battery cover by inserting the tabs into the notches. Press the battery cover closed; the release tab locks the cover in place. Battery cover Release tab Lithium-ion battery Warning: This product contains a lithium-ion battery. To prevent damage, remove the unit from the vehicle when exiting or store it out of direct sunlight. Replacement Battery If you need to replace the battery, use a Garmin 3.7 Volt lithium-ion battery pack (010-10840-00). Purchase a replacement battery at http://buy.garmin.com. You can also use a compatible cell phone battery, such as a Nokia BL-5C. ➋ Charge the GPS 10x Receiver 1. Plug the small end of the power cable into the miniUSB connector on the end of the GPS 10x. 2. Plug the other end of the power cable into an available power outlet in your vehicle. You can use the GPS 10x receiver while you are charging it. It takes about four hours to charge the battery. A fully charged battery lasts about 22 hours. ➌ Install Garmin Mobile® PC on Your Laptop Garmin Mobile PC is compatible with Windows® 2000 SP2, XP, and Windows Vista® operating systems.  Garmin Mobile PC with Wireless GPS Receiver Quick Start Manual