Garmin 010-11024-00 USB Data Card Programmer - Page 13
Trouble Shooting
UPC - 753759074951
View all Garmin 010-11024-00 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Trouble Shooting Symptom Trouble Shooting Guide Probable Cause Remedy Windows does not recognize that the Programmer has been connected to the computer. USB Connector is not properly inserted into the USB port on the computer. USB Port on your computer is not properly configured. Be certain the Programmer has been properly connected to your computer. Consult your computer supplier. When preparing to transfer data, a System operating software is not USB "No compatible device available." message compatible. appears. Programmer is not connected to USB port. Be certain the computer is operating on Windows 98/ME/2000 software. Reconnect the USB Connector to the computer. Card Programmer drivers are not installed. Install drivers. When preparing to transfer data, a "There is no data card in the Programmer." message appears. No Data Card has been inserted in the Programmer. The Data Card is not fully inserted into the Programmer. Insert a Data Card into the Programmer. Push the Data Card fully into the slot in the Programmer. When properly inserted, the card will protrude approximately 1/2 inch from the slot. "An unrecognized data card is in the programmer." message appears when you attempt to transfer data. The Data Card in the Programmer is damaged. MapSource must be updated to be compatible with the card. Insert a different card and try again. Update MapSource software from the Garmin web site. 6