Garmin Aviator Action Pack D2â„¢ and VIRB Elite Aviation Bundle - Page 7

If you need to remove the battery, wait until the screen turns off before removing the battery. Turning the Device On and Off Using REC You can use REC to turn the device on and off in recording mode. This feature allows you to start recording quickly, while automatically turning off the device to conserve battery power when you are not recording. NOTE: The device does not turn off using REC unless you use REC to turn on the device. 1 With the device turned off, slide REC toward the lens. The device turns on and starts recording video. 2 When you are finished recording, slide REC away from the lens. The device stops recording and turns off. Modes You can operate your device in several modes. VIEWFINDER: Displays the camera viewfinder and status information. PLAYBACK: Allows you to view recorded videos and photos. DASHBOARD: Displays sensor data in charts and data fields (VIRB Elite only). SETUP: Allows you to change camera settings. Changing Modes 1 Select MODE to cycle through the available modes. Leveling the Device NOTE: This feature is available for VIRB Elite only. You can use the on-screen level when you mount the device to ensure your videos and photos are perfectly level. 1 Select MODE > VIEWFINDER > . The level appears. 2 Adjust the device until the degree of roll À and degree of pitch Á are both 00°, and the brown section of the level  is even with the horizon line Ã. Calibrating the Level You can calibrate the level if it does not seem accurate. It may be necessary to calibrate the level when using the device in extreme temperatures. 1 Select MODE > VIEWFINDER > . 2 Place the device flat on a level surface, with the screen facing up. 3 Select OK. Status Page The status page provides at-a-glance details about the current settings of your device. Select MODE > VIEWFINDER > . The modes cycle from left to right. The icon for the selected mode appears larger, and the name of the selected mode appears at the bottom of the screen. 2 Stop selecting MODE when the desired mode appears. Viewfinder You can use the viewfinder to set up shots, view status information, and level the camera (VIRB Elite only). Select MODE > VIEWFINDER. À Displays the video mode, field of view, elapsed time, interval or loop setting (if set), number of stored videos, and time remaining on the memory card. Á Displays the photo resolution, camera mode, timer count (if set), photos remaining, and number of stored photos.  Displays the sensors being used (VIRB Elite only) including Wi-Fi®, cadence, heart rate, tempe™, and GPS. The sensor icons are gray when disabled, flashing when searching for a signal, and white when enabled or connected. À Battery status Á Recording time remaining on the memory card  Current video mode Select to view the level (Leveling the Device). Select to view the status page (Status Page). Video Recording a Video NOTE: If the battery power becomes very low while recording video, the device automatically stops recording, saves the video, and safely turns off. 1 Slide REC toward the lens to start recording video. If the device is off, it turns on automatically. The device starts recording video, and the viewfinder appears. Viewfinder 3