Garmin Delta Upland XC Owners Manual - Page 6

Before you put the collar on the dog, remove the charging clip. If you do not remove the clip, it may become detached from the collar and become lost. You should fully charge the battery before you use the device for the first time. Charging a fully depleted battery takes about two hours. The device does not charge when outside the temperature range of 0° to 40°C (32° to 104°F). 1 Snap the charging clip onto the device. À 2 Plug the small end of the power cable into the mini-USB port on the charging clip. Á 3 Plug the other end of the power cable into a power source. The status LED is solid red when the collar is charging. 4 After the status LED turns solid green, remove the charging clip from the collar. NOTE: The dog collar device returns to factory default settings each time it is charged or turned off. Attaching the Devices to the Collar Strap 1 With the buckle facing outward, insert the end of the collar strap through theÀslot on the collar device. Á 2 Pull approximately two-thirds of the collar strap through the slot. 3 Insert the end of the collar strap through the slot on the  opposite side of the device. 4 Pull the strap until it is tight across the front of the device. 5 Insert the end of the collar strap through the slot on the Beeper device. à 2 Turning On the Devices • On the handheld device, hold the power key until the LCD display turns on. • On the dog collar device, hold the power key until the status LED flashes and the collar beeps. • On the beeper device, hold the power key until the red status LED flashes once. Turning Off the Devices • On the handheld device, hold the power key until the LCD display turns off. • On the dog collar device, hold the power key until the status LED flashes and the collar beeps. • On the beeper device, hold the power key until red status LED turns off, and then release the power key immediately. Dog Collar Devices You can use up to three dog collar devices with a single handheld device. You can select a different training mode and intensity level for each dog collar device. Each dog collar device must be paired with the handheld device before it can be used. During the pairing process, each dog collar device is associated with a color on the handheld device. indicates the selected color. Pairing a Dog Collar Device with the Handheld Device NOTE: If your handheld device and dog collar device were included in the same package, the devices are paired from the factory using the black color selection. 1 Turn on the dog collar device and the handheld device. 2 On the handheld device, select to choose a color. indicates the selected color. 3 On the handheld device, select an intensity level greater than 0 (Changing the Intensity Level). 4 On the dog collar device, hold the power key. You must continue to hold the power key during the pairing process. The device beeps once when you select the power key and again after five seconds. 5 After the second beep, select a training key on the handheld device. The dog collar device turns off and beeps to indicate whether the devices paired successfully. Short beep Long beep Devices paired successfully Devices did not pair TIP: If the devices did not pair successfully, you should verify the batteries in both devices are fully charged and the intensity level is set higher than 0. Selecting a Dog Collar Device Before you can select and control a dog collar device, you must pair the dog collar device with the handheld device (Pairing a Dog Collar Device with the Handheld Device). Select to choose the color. Getting Started