Garmin Edge 305CAD Quick Start Guide - Page 1
Garmin Edge 305CAD - Cycle GPS Receiver Manual
UPC - 753759051716
View all Garmin Edge 305CAD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Getting Started 1 power • Press and hold to turn unit on/off. • Press to turn backlight on/off. 2 mode • Press to switch modes. 1 • Press to return to the previous page. 3 reset/lap • Press and hold to reset the timer. • Press to create a new lap. 2 ���� 6 5 4 start/stop Press to start/stop the timer. 3 ��� 4 5 up/down • Press to highlight options. • Press to scroll through menus and data fields. • Press to adjust contrast when on the Satellite page. 6 enter Press to select options and to acknowledge messages. Note: If the Edge locks up, press mode and reset/lap simultaneously to reset the unit. ➊ Charge the Battery 1. On the back of the Edge, pull up the weather cap from the mini-USB port. Make sure that this area is completely dry to prevent corrosion. 2. Plug the mini-USB end of the charger into the mini-USB port on the unit. 3. Plug the A/C charger into a standard wall outlet. Charge the Edge for at least 3 hours before using. When the battery is completely charged, it can run for approximately 12 hours before recharging. mini-USB port under weather cap ➋ Mount the Edge You can install the bike mount to the stem or handlebars. The stem installation (shown here) provides a more sturdy location. Make sure that the Edge is facing up for the best GPS reception. To install the Edge on your bike stem: 1. Place the wedge on the bike stem, and then place the bike mount on the wedge. Make sure the release lever is on the left. For horizontal bars: Separate and remove the top part of the 2. Attach the bike mount securely using two cable ties. Note: Make sure the cable ties are threaded through both parts of the bike mount. 3. Align the Edge with the bike mount so that the unit is vertical. 4. Slide the unit left until it snaps into place. release lever bike mount wedge (optional) mount, turn it 90 degrees, and replace. Continue with step 2. For bars with a diameter less than 1 in (25.4 mm): Place the additional rubber pad under the bike mount to increase the diameter of the bar. The rubber pad also keeps the mount from slipping. Continue with step 2. ➌ Configure the Edge When you first turn on your Edge, the following setup screens appear. Follow the on-screen instructions. To configure your Edge: 1 2 3 4 5 Screens 4 and 5 apply to Edge 305 only. cable ties release lever To release the unit: Press down on the release lever, and slide the unit to the right. ➍ Acquire Satellites Acquiring satellite signals may take 30-60 seconds. For troubleshooting information, refer to the owner's manual. To acquire satellite signals: Go outdoors to an open area. Press and hold the Power button to turn on the Edge. On the Satellite page, the available satellites are flashing while the Edge searches for satellite signals. Acquired satellites and each corresponding bar below change to solid. The GPS accuracy appears at the top of the page. Wait while the Edge searches for satellites. For best reception, make sure the Edge is facing up. Stand still in an open area, and do not begin moving until the Satellite page disappears. After the Satellite page disappears, you can begin your ride. ����