Garmin GC 200 Installation Instructions - Page 2

GC™ 200 IP Marine Camera Installation Instructions Mounting Considerations WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. You can mount the camera upside-down or sideways. You can reverse the camera image to use in rearview mode. See your chartplotter owner's manual for instructions. NOTE: You must update your chartplotter software to setup and view the camera feed on your chartplotter. • You must mount the camera in a location where it is not submerged, does not present a hazard in doorways or walkways, and cannot be damaged by docks, pilings, or other pieces of equipment. • You should mount the camera in a location strong enough to support the weight of the device and where you can remove the camera. • You should mount the camera so the LED is visible and the cables can be connected easily. • To avoid interference with a magnetic compass, do not mount the camera closer to a compass than the compasssafe distance value listed in the product specifications. • You should test the camera in the selected location before you permanently mount the camera. • You can use the Garmin® Power Module to help make the installation easier. The Power Module uses a single camera cable instead of separate power and ethernet cables. This is especially beneficial when the camera is located far away from other electronics, such as near the bow or on a mast. Tools Needed • Drill and 2 mm (1/16 in.) drill bit • Pozidriv® screwdriver Mounting the Camera 1 Secure the template to the mounting location. 2 Using a 2 mm (1/16 in.) drill bit, drill the pilot holes. 3 Using the included hex wrench, loosen the screw in the side of the camera base. 4 Remove the base from the camera body. 5 Feed the camera cables through the camera base, or through one of the cable channels. 6 Align the camera base with the pilot holes, and secure the camera base with the washers and screws . 7 Attach the camera to the base, and tighten the screw in the camera base. 8 Connect the camera cables. 9 Align the slots on the camera base with the collar lugs , and turn the collar until it locks. Connection Considerations Connection Diagram with Direct Power GC™ 200 marine IP camera Garmin Marine Network cable small connector (included) Garmin Marine Network Adapter Cable small to large (included) 9 to 18 Vdc power source (not included) NOTICE To avoid permanently damaging the camera, do not connect the camera directly to a 24 Vdc system. You must use a Garmin Power Module when connecting to a 24 Vdc system. 1 A fast-acting fuse (required, not included) NOTICE You must connect the power wire through a 1 A fast-acting fuse (not included). Without a fuse, the device can malfunction. Garmin chartplotter (not included) Connection Diagram with a Garmin Power Module GC 200 marine IP camera Garmin Marine Network cable small connector Power module (010-12527-00, not included) In-line switch (not included) 9 to 32 Vdc power source (not included) Chartplotter (not included) 2 Installation Instructions