Garmin GHP 20 Marine Autopilot System for Yamaha Helm Master Installation Inst - Page 1
Garmin GHP 20 Marine Autopilot System for Yamaha Helm Master Manual
View all Garmin GHP 20 Marine Autopilot System for Yamaha Helm Master manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
GHP™ 20 Steer-by-Wire Installation Instructions To obtain the best possible performance and to avoid damage to your boat, install the Garmin® GHP 20 marine autopilot system according to the following instructions. Professional installation of the autopilot system is highly recommended. This autopilot system is designed to interface with your specific type of boat. If you are not sure that this system is designed for use with your boat, contact your Garmin dealer or Garmin product support. Read all installation instructions before proceeding with the installation. If you experience difficulty during the installation, contact Garmin Product Support. NOTE: There is an installation checklist on the last page of these instructions. Remove the last page and refer to the checklist as you proceed through the GHP 20 installation. Registering the Device • Go to http://my.garmin.com. • Keep the original sales receipt, or a photocopy, in a safe place. For future reference, write the serial number assigned to each component of your GHP 20 system in the spaces provided on page 3. The serial numbers are located on a sticker on each component. Important Safety Information Warnings You are responsible for the safe and prudent operation of your vessel. The GHP 20 is a tool that will enhance your capability to operate your boat. It does not relieve you from the responsibility of safely operating your boat. Avoid navigational hazards and never leave the helm unattended. Always be prepared to promptly regain manual control of your boat. Learn to operate the GHP 20 on calm and hazard-free open water. Use caution when operating the GHP 20 near hazards in the water, such as docks, pilings, and other boats. See the Important Safety and Product Information guide in the product box for product warnings and other important information. caution Equipment to be connected to this product should have a fire enclosure or be provided with a fire enclosure. Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. Notice When drilling or cutting, always check the opposite side of the surface. Be aware of fuel tanks, electrical cables, and hydraulic hoses. Contacting Garmin Product Support • Go to www.garmin.com/support and click Contact Support for incountry support information. • In the USA, call (913) 397.8200 or (800) 800.1020. • In the UK, call 0808 2380000. • In Europe, call +44 (0) 870.8501241. GHP 20 Installation Instructions 1