Garmin GMA 350H Pilot's Guide - Page 23

Clearance Recorder And Player

Page 23 highlights

GMA 350H Audio Panel 3D Audio Troubleshooting Symptom(s) Cause(s) Solution(s) "3D audio 1) Stereo headset is on left" message backwards heard in right ear only followed by "3D audio right" message heard in left ear only 2) Incorrect aircraft wiring (left/right channels swapped) 1) Verify correct orientation from the left/right indication on each side of the headset or the position of the boom mic (usually attached on left side). If the headset is backwards left/ right position information will be swapped. 2) See a service center as soon as possible to inspect/correct wiring. This wiring fault can cause fail-safe audio not to function. "3D audio left" message heard in left ear only, no audio heard in right ear. 1) Aircraft wired for mono intercom 1) See a service center to wire the installation for stereo headsets. "3D audio 1) Incorrect aircraft right" message wiring (right channel heard in right used for mono ear only, no instead of left, or left/ audio heard in right swapped) left ear 1) See a service center as soon as possible to inspect/correct wiring. This wiring fault can cause fail-safe audio not to function. 3D Audio Troubleshooting CLEARANCE RECORDER AND PLAYER The GMA 350H contains a digital clearance recorder that records up to 2.5 minutes of the selected COM radio signal. Recorded COM audio is stored in separate memory blocks. Once 2.5 minutes of recording time have been reached, the recorder begins recording over the stored memory blocks, starting from the oldest block. 190-01134-14 Rev. B Garmin GMA 350H Pilot's Guide 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

190-01134-14 Rev. B
Garmin GMA 350H Pilot’s Guide
23
GMA 350H Audio Panel
3D Audio Troubleshooting
Symptom(s)
Cause(s)
Solution(s)
“3D audio
left” message
heard in
right ear only
followed by
“3D audio
right” message
heard in left
ear only
1)
Stereo headset is on
backwards
1)
Verify correct orientation from
the left/right indication on
each side of the headset or
the position of the boom mic
(usually attached on left side).
If the headset is backwards left/
right position information will
be swapped.
2)
Incorrect aircraft
wiring (left/right
channels swapped)
2)
See a service center as soon
as possible to inspect/correct
wiring.
This wiring fault can
cause fail-safe audio not to
function.
“3D audio
left” message
heard in left
ear only, no
audio heard in
right ear.
1)
Aircraft wired for
mono intercom
1)
See a service center to wire the
installation for stereo headsets.
“3D audio
right” message
heard in right
ear only, no
audio heard in
left ear
1)
Incorrect aircraft
wiring (right channel
used for mono
instead of left, or left/
right swapped)
1)
See a service center as soon
as possible to inspect/correct
wiring.
This wiring fault can
cause fail-safe audio not to
function.
3D Audio Troubleshooting
CLEARANCE RECORDER AND PLAYER
The GMA 350H contains a digital clearance recorder that records up to
2.5 minutes of the selected COM radio signal.
Recorded COM audio is
stored in separate memory blocks.
Once 2.5 minutes of recording time
have been reached, the recorder begins recording over the stored memory
blocks, starting from the oldest block.