Garmin GMR 604 Open Array Antenna xHD Installation Instructions - Page 6
Connecting the Radar to the Garmin Marine Network
View all Garmin GMR 604 Open Array Antenna xHD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Connecting the Radar to the Garmin Marine Network For a stand-alone network (chartplotter and radar only), attach the RJ-45 marine network cable to the RJ-45 socket on the back of the chartplotter. For an expanded network (including a chartplotter, radar, a GMS 10, etc.), attach the RJ-45 marine network cable to an open RJ-45 socket on the GMS 10 network expander. Tighten the RJ-45 locking ring clockwise until it is firmly sealed. GMR 400/600/1200 xHD radar Garmin Marine Networkcompatible chartplotter GMR 400/600/1200 xHD radar Stand-Alone Garmin Marine Network Example GSD 22 sounder unit GMS 10 marine network port expander xxxx xxx To transducer xxxxxxxxxxxxxxxxxxxx GDL 30/30A XM weather receiver Garmin GPSMAP 3000 series chartplotter Garmin GPSMAP 4000/5000 series chartplotter Expanded Garmin Marine Network Example NOTE: Each component of the expanded network must be installed according to its installation instructions. These diagrams only show how a GMR 404/406 radar interacts with a network and do not show proper wiring for other network components. NOTE: Every device connected to the Garmin Marine Network must be connected to the power supply for the boat. These diagrams show the network connections; however, they do not show the power connections. Wire each device according to the appropriate installation instructions. 6 GMR 400/600/1200 xHD Installation Instructions