Garmin GPS 17x NMEA 2000 Installation Instructions - Page 3
GPS 17x NMEA 2000, Installation Instructions - cable
View all Garmin GPS 17x NMEA 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
EN GPS 17x NMEA 2000® Installation Instructions The Garmin GPS 17x NMEA 2000 high-sensitivity GPS antenna provides position information to your existing NMEA 2000 network. If you do not have an existing NMEA 2000® network on your boat, you will need to install one. For more information about NMEA 2000, visit www.garmin.com. The GPS 17x antenna must be properly installed according to the following instructions. You need the appropriate fasteners, tools, and mounts listed in each section. These items are available at most marine dealers. Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. When drilling or cutting, always check what is on the opposite side of the surface. If you experience difficulty installing the unit, seek the assistance of a professional installer or contact Garmin Product Support by phone at 913/397.8200 or 800/800.1020. Go to www.garmin.com/support/ for more information. In Europe, contact Garmin (Europe) Ltd. at 44/0870.8501241. WARNING: See the Important Safety and Product Information guide in the product box for product warnings and other important information. Product Registration Help us better support you by completing our online registration at www.garmin.com /registration/. For future reference, write the serial number assigned to your GPS 17x in the space provided. It is located on a sticker on the back of the unit. Serial number Packing List and Accessories Before installing your unit, confirm that your package includes the following items. If any parts are missing, contact your Garmin dealer immediately. Standard Package • GPS 17x Antenna Tools Needed • Drill • Surface-mount bracket • Pole-mount bracket • Under-deck mount bracket • Drill bit-11/8 in (3.2 mm) • Drill bit-3/4 in (19 mm) pole-mount cable- hole • Mounting hardware (screws and adhesive pads) • Hole saw, 1 in (25 mm)-surface-mount cable-hole • NMEA 2000 T-connector • NMEA 2000 drop cable 6.5 ft. (2 m) • Installation instructions Optional Accessories • Additional NMEA 2000 network components • Screwdriver-surface mount screws • Center punch and hammer (to mark surface-mount pilot holes) • Countersink bit (when mounting on fiberglass) • Marine sealant (for some mounting options) October 2009 190-00886-10 Rev. A Printed in Taiwan