Garmin GPSMAP 441s Flush Mount Kit Instructions (Multilingual) - Page 2

Tighten the 4 wing nuts to secure the unit housing to the mounting surface. Be careful not - with transducer

Get Garmin GPSMAP 441s PDF manuals and user guides View all Garmin GPSMAP 441s manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

EN 3. Install the unit in the opening (see Figure 2): • Place the unit housing in the recently cut hole in the mounting surface. • Slide the tension mount arms onto the hex bolts and secure them with the (4) wing nuts. • Tighten the (4) wing nuts to secure the unit housing to the mounting surface. Be careful not to overtighten. Assembled unit and flush mount hardware Tension mount brackets Wing nuts Figure 2 NOTE: If you are installing a Fishfinder 400C, the wiring harness must be connected to the boat's power supply and transducer per the installation instructions included with the unit. NOTE: If you are installing a GPSMAP 400 series unit, you must connect the wiring harness to the boat's power supply, GPS antenna, XM antenna (if applicable), and transducer (if applicable) per the installation instructions included with the unit.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
3. Install the unit in the opening (see Figure 2):
Place the unit housing in the recently cut hole in the mounting surface.
Slide the tension mount arms onto the hex bolts and secure them with the (4) wing nuts.
Tighten the (4) wing nuts to secure the unit housing to the mounting surface. Be careful not to overtighten.
Assembled unit and
flush mount hardware
Tension mount brackets
Wing nuts
Figure 2
NOTE:
If you are installing a Fishfinder 400C, the wiring harness must be connected to the boat’s power supply and transducer per the installation
instructions included with the unit.
NOTE:
If you are installing a GPSMAP 400 series unit, you must connect the wiring harness to the boat’s power supply, GPS antenna, XM antenna
(if applicable), and transducer (if applicable) per the installation instructions included with the unit.
•
•
•
EN