Garmin GPSMAP 8012 MFD Installation Instructions - Page 1

GPSMAP® 8000 Series Installation Instructions Important Safety Information WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product specifications. In addition, connecting the power cable without the appropriate fuse in place will void the product warranty. CAUTION Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. NOTICE When drilling or cutting, always check what is on the opposite side of the surface. Registering Your Device Help us better support you by completing our online registration today. • Go to http: / / my .garmin .com. • Keep the original sales receipt, or a photocopy, in a safe place. Contacting Garmin Product Support • Go to www.garmin.com/ support and click Contact Support for in-country support information. • In the USA, call (913) 397. 8200 or (800) 800. 1020. • In the UK, call 0808 2380000. • In Europe, call +44 (0) 870. 8501241. Tools Needed • Drill and drill bits • #2 Phillips screwdriver • Marine sealant • Jigsaw • File and sandpaper Mounting the Components Mounting Considerations NOTICE This device should be mounted in a location that is not exposed to extreme temperatures or conditions. The temperature range for this device is listed in the product specifications. Extended exposure to temperatures exceeding the specified temperature range, in storage or operating conditions, may cause device failure. Extreme-temperature-induced damage and related consequences are not covered by the warranty. You can mount the device using one of three methods. You can use the included bracket and hardware to bail mount the device, you can use the included template and hardware to flush mount the device, or you can use the flat-mount kit (sold separately) to mount the device flat with the dashboard. When selecting a mounting location, observe these considerations. NOTE: Not all mounting methods are available for all device models. See the specific mounting-type section for more details about your model. • The location should provide optimal viewing as you operate your boat. • The location should allow for easy access to all device interfaces, such as the keypad, touchscreen, and card reader, if applicable. • The location must be strong enough to support the weight of the device and protect it from excessive vibration or shock. • To avoid interference with a magnetic compass, the device should not be installed closer to a compass than the compass-safe distance value listed in the product specifications. • The location must allow room for the routing and connection of the cables. Bail Mounting the Device NOTICE If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a clearance counterbore through only the top gel-coat layer. This will help to avoid any cracking in the gel-coat layer when the screws are tightened. The bail-mounting hardware (screws and washers or nuts, washers, and bolts) is not included. The holes on the bail-mount bracket are 5/16 in. (7. 9 mm) in diameter. Before you can bail mount the device, you must choose mounting hardware that fits the holes in the bail-mount bracket and securely attaches it to your specific mounting surface. The size of the pilot hole required depends on the mounting hardware you choose. You can bail mount only the eight-inch and 12-inch models. Due to the size of the 15-inch models, you must install them using the flush-mount or flat-mount method. 1 Using the included bail-mount bracket as a template, mark À the location of the four pilot holes . Á 2 Using a drill bit appropriate for your mounting hardware, drill the pilot holes. 3 Secure the bail-mount bracket to the surface using your mounting hardware . Â 4 Install the bail-mount knobs on the sides of the device. Ã December 2012 190-01557-02_0A Printed in Taiwan