Garmin StreetPilot 7200 Quick Reference Guide - Page 1

Getting Ready Congratulations on purchasing a StreetPilot 7200/7500! Follow the mounting and setup steps in this guide to get started. See the back of this sheet to start using your StreetPilot. For more information, see the owner's manual that came in the box. What's in the Box Remove the following items from the box. You will need these items to mount the StreetPilot and get started. 7200/7500 Unit Mounting Base on Mounting Plate Mounting Cradle with Power Cable IN OUT ZOOM MENU MAP BACK SPEAK PAGE VOL 1 ABC 2 DEF 3 GHI JKL MNO 4 5 6 PQRS 7 TUV 8 WXYZ 9 0 Remote Control StreetPilot® 7200/7500 set up and go! May 2006 © Copyright 2005-2006 Garmin Ltd. or its subsidiaries 190-00454-01 Rev. B Printed in Taiwan ➊Attach the mounting plate to your dashboard. 1. Clean the area where you want to place the mount with rubbing alcohol. Dry with a clean dry cloth. 2. Remove the liner from the bottom of the mounting plate. A 3. Place the mounting plate in the selected location. Mounting cradle StreetPilot B 4. Bend the edges of the mounting plate to fit the surface. ➋Attach the mounting cradle to the StreetPilot. Attaching the Cradle to the StreetPilot Puck 1. Place the two tabs on the cradle into the two grooves on the top of the StreetPilot. (A) 2. Swing the cradle forward so that the StreetPilot is fully seated in the cradle. (B) 3. Slide the cradle's locking lever to the right (locked). ➌Slide the mounting cradle into the base on the mounting plate. 1. Slide the bottom of the mounting cradle into the mounting base. 2. Slide the base's locking lever to the right (locked). Locking lever 3. Plug the power cable into a 12-Volt receptacle in your vehicle. 4. Route the cable so it does not interfere with vehicle operation. Power button Sliding the Mount in the Base Warning: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the StreetPilot 7200/7500 installed to place and secure the device so it does not interfere with the vehicle operating controls and safety devices, obstruct the driver's view of driving conditions, or cause personal injury in the event of an accident. ➍Configure your StreetPilot If necessary, turn the key in the ignition to apply power to the StreetPilot. Follow the screen prompts to set up your StreetPilot: ➊ Select a language. Touch Next. ➋ Touch a time zone. Touch Next. ➌ Select an option. Touch Next. ➍ Select an option. Touch Next. ➎ Wait a few minutes. ➏ Touch Done.