Garmin VHF 200 Marine Radio Installation Instructions - Page 7

4. Add additional T-connectors for each device you want to add to the NMEA 2000 network, and connect each device to a T-connector with a drop cable. 5. Connect terminators (not included) to each end of the combined T-connectors. Ignition or in-line switch Fuse + - 12 Vdc battery Drop cable NMEA 2000 device Power cable Female terminator T-connectors Male terminator Creating a Basic NMEA 2000 Network NMEA 2000 PGN information Use this table to determine the approved NMEA 2000 PGN information that can be received and transmitted by a VHF 200 series radio when communicating with a NMEA 2000-compliant device. Receive 059392 059904 060928 126208 129026 129029 ISO Acknowledgment ISO Request ISO Address Claim NMEA - Command/Request/Acknowledge Group Function COG (course over ground) and SOG (speed over ground) - Rapid Update GNSS (Global Navigation Satellite System) Position Data Transmit 059392 060928 126208 126464 126996 129799 129808 ISO Acknowledgment ISO Address Claim NMEA Request/Command/ Acknowledge Group Function PGN List Product Information Radio Frequency/Mode/Power DSC Call Information Garmin VHF 200 Series radios are NMEA 2000 certified. Connecting the VHF 200 Series Radio to a Hailer Horn (Optional) The radio can be connected to a hailer horn that will allow using the microphone or the GHS 10 handset to make announcements through your public address system. To mount the hailer horn, refer to the installation instructions that came with the device. Mount the hailer horn at least 10 ft. (3 m) away from the microphone and facing away from the microphone to avoid feedback. To connect the VHF 200 series radio to a hailer horn: 1. Attach the included 23 in. (600 mm) hailer cable to the cable on the rear panel of the radio by connecting the red RCA plug into the red jack. 2. Connect the white wire on the other end of the hailer cable to the positive (+) connection on the hailer. 3. Connect the black wire to the negative (-) connection on the hailer. CAUTION: Cover the connections with a waterproof, adhesive tape, such as rubber vulcanizing tape, to prevent water from seeping into the radio. Refer to the VHF 100/200 Series Owner's Manual to operate the hailer. VHF 100/200 Series Radio Installation Instructions