Garmin VIB 10 Installation Guide - Page 2

Warning Failure to avoid the following potentially hazardous situations could result in an accident or collision resulting in death or serious injury. • Do not open the VIB or loosen the case screws. Doing so will void the warranty. • When extending ignition, battery, or ground wires, use automotive-grade wires or other wires with AWG 18 (0.75 mm2) gauge or greater. • Connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, such as battery wires, the vehicle's battery may die. • Make sure to ground the VIB to the chassis of the vehicle. • Secure all wiring with cable clamps or electrical tape. Insulate unconnected wires; do not allow any bare wiring to remain exposed. • Do not let unconnected wires or terminals touch metal on the vehicle or anything else that can conduct electricity. • Do not expose the unit to water or other liquids. The unit is not waterproof. • Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity, or dust. VIB 10/11 24-Pin Connector Ignition 12 VDC Ground Note: There may be additional signals from the stereo that are not shown on this diagram. Any such signals should be connected directly back to the stereo. VIB 10/11 Wiring Diagram Reverse In 1 Mute Out 2 Pink Light Green Optional Optional Stereo VIB 10/11 24-Pin 2 Connector 24 1 23 Video In VIB 10/11 Connectors To Stereo/ vehicle wiring (24-pin connector) To PND (GPS navigator) Ground In 3 Ground In 4 12 VDC In 5 12 VDC In 6 Ignition 7 Output Level 8 LR (-) Out 9 LR (+) Out 10 RR (-) Out 11 RR (+) Out 12 LF (-) Out 13 LF (+) Out 14 RF (-) Out 15 RF (+) Out 16 Ant Out to stereo's antenna connector (VIB 11 Only) Ant In from vehicle's antenna (VIB 11 Only) VIB 11 Antenna Connections Audio Out (optional) To Stereo Adapter Cable LR (-) In 17 LR (+) In 18 RR (-) In 19 RR (+) In 20 LF (-) In 21 LF (+) In 22 RF (-) In 23 RF (+) In 24 Black Black Yellow Yellow Red Tan Green/Black Green Purple/Black Purple White/Black White Grey/Black Grey Ground for Low-level output; Float for High-level output Green/Black Green Purple/Black Purple White/Black White Grey/Black Grey To Antenna Adapter Cable Vehicle Ground 12 VDC Ignition Vehicle Speakers LR (-) LR (+) RR (-) RR (+) LF (-) LF (+) RF (-) RF (+) Stereo System Out LR (-) LR (+) RR (-) RR (+) LF (-) LF (+) RF (-) RF (+) Stereo's antenna connector adapter to stereo Fakra to VIB 11 Ant. Out Fakra to VIB 11 Ant. In adapter to antenna Vehicle's antenna