Gastroback 41406 User Manual - Page 10
Assembling for making Kebbe
View all Gastroback 41406 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
2. Take the adaptor disc. The small end with the recess has to face the worm when attaching. If necessary turn the adaptor disc a little bit until the arresting pin of the worm housing locks precisely into the corresponding recesses of the adaptor disc. IMPORTANT: If the tools overlap the edges of the worm housing the worm is not placed all the way inside of the worm housing. Turn the worm a little bit to make it fit inside but do not use force. If mounted correctly the adaptor disc is flush with the front of the worm housing and the axis of the worm pokes out 2 mm of the adaptor disc. 3. Place the sausage attachment on the worm housing and fit J the closure ring over the sausage attachment (picture J). Firmly screw the closing ring on the worm housing and tighten by hand. ATTENTION: Do not use any tools, for tightening the screw and pay attention not to cant the screw. If the screw cants the screw thread gets damaged. If the screw does not turn easily put some sunflower oil (or other edible oil) on the screw. 4. Refer to ´Assembling for mincing` step 3 for further steps for assembling. Assembling for making Kebbe 1. Picture A: Take the worm housing into the right A hand and insert with your left hand the worm inside the worm housing. The side of the worm with the plastic end has to face the worm housing when putting it inside the worm housing. If the worm is correctly assembled when the plastic end of the worm pokes a few millimetres out of the worm housing. 2. Take the Kebbe attachment A. The flat end with the recess has to face the worm housing when attaching. If necessary turn the Kebbe attachment A a little bit until the arresting pin of the worm housing locks precisely into the corresponding recesses of the Kebbe attachment A. IMPORTANT: If the tools overlap the edges of the worm housing the worm is not placed all the way inside of the worm housing. Turn the worm a little bit to make it fit inside but do not use force. If mounted correctly the Kebbe attachment A is flush with the front of the worm housing and the axis of the worm pokes out 2 mm of the grinding disc. B 3. Place the Kebbe attachment B on the worm housing and fit the closure ring over the Kebbe attachment B (picture B). Firmly screw the closing ring on the worm housing and tighten by hand. 32