Gateway 9315 Gateway 9315 Server User Guide - Page 120
Bootblock recovery code checkpoints
![]() |
View all Gateway 9315 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
Check Diagnostic LED decoder Description point G=Green, R=Red, O=Orange D6 R O G R Both key sequence and OEM-specific method is checked to determine if BIOS recovery is forced. Main BIOS checksum is tested. If BIOS recovery is necessary, control flows to checkpoint E0. See Bootblock Recovery Code Checkpoints section of document for more information. D7 R O G O Restore CPUID value back into register. The Bootblock-Runtime interface module is moved to system memory and control is given to it. Determine whether to execute serial flash. D8 O R Off R The Runtime module is uncompressed into memory. CPUID information is stored in memory. D9 O R Off O Store the Uncompressed pointer for future use in PMM. Copying Main BIOS into memory. Leaves all RAM below 1 MB Read-Write, including E000 and F000 shadow areas, but closing SMRAM. DA O R G R Restore CPUID value back into register. Give control to BIOS POST (ExecutePOSTKernel).See "POST code checkpoints" on page 111 for more information. E1-E8 - - - - OEM memory detection/configuration error. This range is EC-EE reserved for chipset vendors and system manufacturers. The error associated with this value may be different from one platform to the next. Bootblock recovery code checkpoints The bootblock recovery code gets control when the BIOS determines that a BIOS recovery needs to occur because the user has forced the update or the BIOS checksum is corrupt. The following table provides the diagnostic LED codes for these checkpoints and describes the type of checkpoints that may occur during the Bootblock recovery portion of the BIOS: Check point E0 E9 EA EB Diagnostic LED decoder G=Green, R=Red, O=Orange R R R Off O R R G O R O Off O R O G Description Initialize the floppy controller in the super I/O. Some interrupt vectors are initialized. DMA controller is initialized. 8259 interrupt controller is initialized. L1 cache is enabled. Set up floppy controller and data. Attempt to read from floppy. Enable ATAPI hardware. Attempt to read from ARMD and ATAPI CDROM. Disable ATAPI hardware. Jump back to checkpoint E9. www.gateway.com 115
![](/manual_guide/products/gateway-computers-9315-gateway-9315-server-user-guide-fde89e2/120.png)