Gateway GT5475E 8512041 - Gateway Hardware Reference Guide (5-bay uATX Case) - Page 21
Checking the voltage selection
View all Gateway GT5475E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
www.gateway.com Checking the voltage selection Caution If you set the voltage selection switch incorrectly, your system will be damaged. Make sure this switch is set correctly for your location before turning on your computer. In the United States, the utility power is supplied at a nominal 115 volts at 60 Hz. The power supply should always be set to this when your computer is operating in the United States. In other areas of the world, such as Europe, the utility power is supplied at 230 volts at 50 Hz. If your computer is operating in an environment such as this, the voltage switch should be moved to 230. The power supply, a component built into your computer, provides power to the system board, add-in cards, and peripheral devices. The power supply's voltage selection for your location is typically set at the factory, but you can change it to match the electrical service available in your usage area (such as while in another country). Use the power selection switch on the back of your computer to set the voltage to 115V or 230V. To set the voltage selection switch: 1 Disconnect your computer's power cable. 2 Use a tool such as an opened paper clip to slide the voltage selection switch to the correct voltage position. The switch is located on the back of your computer, near the power cable connector. To see its location, see "Back" on page 8. 15