GE 28811FE1 User Guide - Page 46

Handset Sound Signals, Troubleshooting Guide - a battery

Get GE 28811FE1 - Digital Cordless Phone PDF manuals and user guides
UPC - 044319805079
View all GE 28811FE1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

Handset Sound Signals Signal A long warbling tone (with ringer on) Meaning Signals an incoming call Three short beeps (several times) Page signal One beep every 7 seconds Low battery warning Troubleshooting Guide Telephone Solutions No dial tone • Check or repeat installation steps: Make sure the base power cord is connected to a working electrical outlet. Make sure the telephone line cord is connected to the base and the wall jack. • Connect another phone to the same jack. If it doesn't work, the problem might be your wiring or local service. • The handset may be out of range of the base. Move closer to the base. • Make sure the battery is properly charged (for 16 hours). • Make sure the battery pack (in the handset) is properly installed. • The handset should beep when you press the TALK button, and the charge indicator on the base should be lit when the handset rests in the cradle. If not, the battery may need to be charged. • Place handset in charge cradle for at least 20 seconds to reset the unit. 46

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
³6
Handset Sound Signals
Signal
Meaning
A long warbling tone
Signals an incoming call
(with ringer on)
Three short beeps
Page signal
(several times)
One beep every 7 seconds
Low battery warning
Troubleshooting Guide
Telephone Solutions
No dial tone
•
Check or repeat installation steps:
Make sure the base power cord is connected to a working electrical outlet.
Make sure the telephone line cord is connected to the base and the wall jack.
•
Connect another phone to the same jack. If it doesn’t work, the problem might be
your wiring or local service.
•
The handset may be out of range of the base. Move closer to the base.
•
Make sure the battery is properly charged (for 16 hours).
•
Make sure the battery pack (in the handset) is properly installed.
•
The handset should beep when you press the TALK button, and the charge
indicator on the base should be lit when the handset rests in the cradle. If not, the
battery may need to be charged.
•
Place handset in charge cradle for at least ±0 seconds to reset the unit.