GE ADT521PGFBS Installation Instructions - Page 7
Dishwasher Installation
View all GE ADT521PGFBS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Dishwasher Installation STEP 6: INSTALL 90° ELBOW • Thread 90° elbow onto the water valve. Use thread seal tape for elbows with 3/8" NPT external threads. • Do not overtighten elbow. Water valve bracket could bend or water valve fitting could break. • Position the end of the elbow to face the rear of the dishwasher. Water Valve Bracket Thread Seal Tape Front of Dishwasher 90° 3/8" NPT Elbow Fill Hose OR Front of dishwasher STEP 8: POSITION WATER LINE AND HOUSE WIRING • Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher. 4" 4" 6" 6" Water House Line Wiring Water Valve Bracket Figure M Figure K 90° 3/4" GHT Elbow Fill Hose STEP 9: INSTALL DRAIN HOSE, THROUGH CABINET • Position dishwasher in front of cabinet opening. Insert drain hose into the hole in cabinet side. If a power cord is used, guide the end through a separate hole. STEP 7: INSTALL DRAIN HOSE TO DRAIN LOOP Connect drain loop end to drain hose using the screw clamp as shown in the figure. Insulation Blanket Maximum Drain Hose Length 10' Water Line Figure L Drain Hose House Wiring Power Cord (If Used) Figure N 7LS3UHYHQWXQQHFHVVDU\VHUYLFHFDOOFKDUJHVIRU¿OOGUDLQRU noise concerns. Position utility lines so they do not interfere with anything under or behind the dishwasher. 7