GE AJCM10ACD Use and Care Manual - Page 7

Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support GEAppliances.com COOL MODE Remote Control 1. Press COOL pad. 2. Press LOW or HIGH pads to set desired fan speed. 3. Press the INCREASE + / DECREASE - pads to set the desired temperature 60°F to 85°F in 1°F increments. Control Panel 1. Press the MODE pad until the COOL indicator light is lit. 2. Press the FAN pad until HIGH or LOW indicator light is lit for desired fan speed. 3. Press the INCREASE + / DECREASE - pads to set the desired temperature 60°F to 85°F in 1°F increments. A thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer. NOTE: If the air conditioner is off and is then turned on while set to COOL, it will take approximately 3 minutes for the compressor to start and cooling to begin. Cooling Descriptions For Normal Cooling-Select the COOL mode and HIGH fan with a middle set temperature. For Maximum Cooling-Select the COOL mode and HIGH fan with a lower set temperature. For Quieter and Nighttime Cooling-Select the COOL mode and LOW fan with a middle set temperature. NOTE: There will be a 3-minute delay between setting changes such as COOL to OFF and back to COOL. HEAT MODE Remote Control 1. Press HEAT pad. 2. Press LOW or HIGH pads to set desired fan speed. 3. Press the INCREASE + / DECREASE - pads to set the desired temperature 60°F to 85°F in 1°F increments. Control Panel 1. Press the MODE pad until the HEAT indicator light is lit. 2. Press the FAN pad until HIGH or LOW indicator light is lit for desired fan speed. 3. Press the INCREASE + / DECREASE - pads to set the desired temperature 60°F to 85°F in 1°F increments. A thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a higher number and the indoor air will become warmer. Set the thermostat at a lower number and the indoor air will become cooler. NOTE: If the air conditioner is off and is then turned on while set to HEAT, it will take approximately 3 minutes for the compressor to start and heating to begin. Heating Descriptions For Normal Heating-Select the Heat mode and HIGH fan with a middle set temperature. For Maximum Heating-Select the HEAT mode and HIGH fan with a higher set temperature. For Quieter and Nighttime Heating-Select the HEAT mode and LOW fan with a middle set temperature. NOTE: There will be a 3-minute delay between setting changes such as HEAT to OFF and back to HEAT. FAN Use the FAN to provide air circulation and filtering without cooling or heating. Since fan only settings do not provide cooling or heating, a temperature setting will not be displayed. Remote Control Press FAN pad. Press LOW or HIGH pads to set desired fan speed. Control Panel Press the MODE pad until the FAN indicator light is lit and the LOW or HIGH indicator light is lit for the desired fan speed. 7