GE AJCQ08ACC Owners Manual - Page 5
Safety Instructions, Care and Cleaning, Installation Instructions, Troubleshooting Tips
UPC - 084691158011
View all GE AJCQ08ACC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support ge.com COOL MODE Remote Control 1. Press COOL pad. 2. Press LOW, MED or HI pads to set desired fan speed. 3. Press the INCREASE L / DECREASE M pads to set the desired temperature 60°F to 85°F in 1°F increments. Control Panel 1. Press the MODE pad until the COOL indicator light is lit and the LOW, MED or HI indicator light is lit for the desired fan speed. 2. Press the INCREASE L / DECREASE M pads to set the desired temperature 60°F to 85°F in 1°F increments. A thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer. NOTE: If the air conditioner is off and is then turned on while set to COOL, it will take approximately 3 minutes for the compressor to start and cooling to begin. Cooling Descriptions For Normal Cooling-Select the COOL mode and HIGH or MED fan with a middle set temperature. For Maximum Cooling-Select the COOL mode and HIGH fan with a lower set temperature. For Quieter & Nighttime Cooling-Select the COOL mode and LOW fan with a middle set temperature. NOTE: If you switch from a COOL setting to OFF or to a fan setting, wait at least 3 minutes before switching back to a COOL setting. Fan Switch The fan switch is located behind the front grille on the control box. Access through a hole in control box. When set at CYCLE (down) the fan cycles on and off. When set at CONT (continuous, up) the fan runs all the time providing a more balanced temperature. The unit is shipped in the CONT setting. FAN MODE Use the FAN mode to provide air circulation and filtering without cooling. Since fan only settings do not provide cooling, a temperature setting will not be displayed. Remote Control Press FAN pad. Press LOW, MED or HI pads to set desired fan speed. Control Panel Press the MODE pad until the FAN indicator light is lit and the LOW, MED or HI indicator light is lit for the desired fan speed. Vent Control The vent control is located behind the front grille on the right side of the air discharge area. When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside. To open or close the vent: 1. Remove the front grille. 2. Remove the vent card screw. 3. Remove vent card, turn it over and replace it by locating rear hole in card over locating pin inside air discharge and reattaching screw at front. The unit leaves the factory set at the CLOSE position. Locating hole Locating hole Screw hole OPEN position (Mesh end toward back) Screw hole CLOSE position (Mesh end toward front) Air Direction Horizontal louvers on the front grille let you control the air direction up and down. Remove the front grille to adjust the vertical louvers side-to-side to direct the air left or right. 5