GE AJCQ10DCD Use and Care Manual - Page 19
Measure, Cut And Install Filler, Panels, The Angles.
UPC - 084691175360
View all GE AJCQ10DCD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Installation Instructions 6 MEASURE, CUT AND INSTALL FILLER PANELS A Measure from the edge of the panel marks (see Prepare the Window) to the inside of the window track on each side (A and B). Sill Window track Outside A Left side 133⁄8″ Inside 133⁄8″ Width of the air conditioner (panel marks) B Right side B Mark the A and B measurements on each side of the filler panel board. Cut the panels and discard the center piece. Note position of the notches. Gasket Angle Angle Gasket Panel Tab Type C (painted screws) D Install the panels in the window. Place the spring clips 3″ from the top and the bottom. Squeeze and push the clips to fit in the window track and the tab into the sill support. B A 3″ Right Left side side Filler Panels Cut panels and discard center piece (holes are on the left) (holes are on the right) C Put together the panel assemblies. Remove the paper backing from the case-side gasket and attach it to the angle. Push a pencil point through the gaskets to locate the holes in the angles. Hook the tab into the sill support 19