GE CDT865SSJSS Installation Instructions - Page 3
IMPORTANT, Installation Preparation - dishwasher
View all GE CDT865SSJSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Installation Preparation PREPARE DISHWASHER ENCLOSURE 33-1/23"4t-o1/324"+-31/4"" UndUenrdsiedrseidoefof CouCnoteunrtteorptop to FtloooFlroor This Wall Area must be Free of Pipes or wires 24" Min. 4" Plumbing and Electric Service Must Enter Inside This Area 6" 24" Min. Cabinets Square and Plumb Figure A • The rough cabinet opening must be at least 24" deep, 24" wide and approximately 34-1/2" high from floor to underside of the countertop. WARNING 7RUHGXFHWKHULVNRIHOHFWULFVKRFN¿UHRULQMXU\WRSHUVRQVWKH installer must ensure that the dishwasher is completely enclosed at the time of installation. • The dishwasher must be installed so that drain hose is no more than 12' in length for proper drainage. • The dishwasher must be fully enclosed on the top, sides and back, and must not support any part of the enclosure. CLEARANCES: • When installed into a corner, allow 2" min. clearance between dishwasher and DGMDFHQWFDELQHWZDOORURWKHU appliances. Allow 25-1/2" min. clearance from the front of the dishwasher for door opening. Figure B. Countertop Dishwasher 25-1/2" Clearance for Door Opening 2" Minimum Figure B DRAIN REQUIREMENTS • Follow local codes and ordinances. • Do not exceed 12' distance to drain. • Drain connection height is not to exceed 72" above bottom of dishwasher. NOTE: Air gap must be used if waste tee or disposer connection is less than 18" above floor to prevent siphoning. DETERMINE DRAIN METHOD The type of drain installation depends on the following questions. • Do local codes or ordinances require an air gap? • Is waste tee less than 18" above floor? If the answer to either question is YES, Method 1 MUST be used. • If the answers are NO, either method may be used. CABINET PREPARATION • Drill a 1-1/2" diameter hole in the cabinet wall within the shaded areas shown in Figure A for the drain hose connection. The hole should be smooth with no sharp edges. IMPORTANT - When connecting drain line to disposer, check to be sure that drain plug has been removed. DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE. Remove Drain Plug Figure C Method 1 - Air Gap with Waste Tee or Disposer An air gap must be used when required by local codes and ordinances. The air gap must be installed according to manufacturer's instructions. Drain Hose Hanger Drain Hose Hanger 32" 18" Min. Min. 32" Min. 18" Min. Figure D Method 2 - "High Drain Loop" with Waste Tee or Disposer Tip: Avoid unnecessary service call charges. Always be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer. 3