GE CDWT980RSS Installation Instructions - Page 15

Dishwasher Installation STEP 20 - DISHWASHER WET TEST ■ Turn on power supply (or plug power cord into outlet, if equipped). ■ Start the unit to check for leaks. Front-Mount Control Models: - Close & latch door - Push RINSE ONLY pad - Push START/RESET pad one time Top-Mount Control Models: - Push RINSE ONLY pad - Push START/RESET pad one time - Close & latch door ■ Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water and power are turned on. ■ Check for leaks under the dishwasher. If a leak is found, turn off power supply, then tighten connections. Restore power after leak is corrected. ■ Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting against adjacent cabinet. Reposition the dishwasher if necessary. See Steps 13, 14 and 15. ■ The dishwasher will drain and turn off about 5 minutes after it was started. Check drain lines. If leaks are found, turn off power supply and correct plumbing as necessary. Restore power after corrections are made. See Step 10 and 17. ■ Open dishwasher door and make sure most of the water has drained. If not, check to be sure disposer plug has been removed and/or air gap is clear. See Step 17. Also check drain line to be sure it is not kinked. ■ Run the dishwasher through another "Rinse Only" cycle. Check for leaks and correct if required. STEP 21 - Set Water Hardness Models with bulk dispenser only. Skip this step if your dishwasher does not have the bulk dispense feature. • Locate the hard water test strip set aside in Step 1. • Remove strip from package. • Turn on the hot water and hold the strip under the stream, following the directions on the package. • Use the value on the test strip to calibrate your dishwasher for water hardness. Refer to the section titled "Water Hardness Calibration" in your Owner's Manual for information on how to calibrate your dishwasher. STEP 22 - INSTALL SOUND UPGRADE KIT IF EQUIPPED Skip this step if your model does not have the Sound Upgrade Kit. • Locate sound upgrade kit set aside in Step 1 and the two screws set aside in Step 6. • Attach the plastic Sound Panel as shown in Figure LL using the two screws. The lower set of mounting holes should be used. • Be sure the sound panel is seated in the notches on frame as shown in Figure JJ. Sound panel is located under door panel. Plastiwc iSthouFnodamPanel Attachment Screws Be sure that the sound panel is seated in the notch in the frame. (Both sides) Figure JJ 15