GE CSA1201RSS Installation Instructions - Page 20
Adapting Blower for Recirculation, AFTER: Fan Blade, Openings Facing, Forward
UPC - 084691210979
View all GE CSA1201RSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installation Instructions C3 ADAPTING BLOWER FOR RECIRCULATION NOTE: The exhaust adaptor with damper is not needed for recirculating models. You may want to save them for possible future use. 1 Remove and save screws that hold blower plate to the oven. Blower Plate Screws Back of Oven 2 Slide the blower plate from under its retaining flange and lift it off. Remove and save screw that holds the blower motor to oven. Retaining Flange Blower Plate 3 Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. 4 Roll the blower unit 90° so that fan blade openings are facing toward the front of the oven. BEFORE: Fan Blade Openings Facing Up Roll Blower Motor Screw AFTER: Fan Blade Openings Facing Forward NOTE: Make sure wires remain routed in the grooves of the motor frame. 20