GE DCVH680EJMS Use and Care Manual - Page 10

Safety Instructions Operating Instructions About cycle options. NOTE: Not all features are available on all dryer models. EXTEND TUMBLE Extend Tumble Minimizes wrinkles by adding approximately 60 minutes of no-heat tumbling after clothes are dry. The beeper will sound every 2 minutes to remind you to remove the clothes. The ESTIMATED TIME REMAINING display will show 00. GEAppliances.com DAMP ALERT Damp Alert (on some models) This option causes the dryer to beep when clothes have dried to a damp level. Remove items that you wish to hang dry. The DAMP AlERT will only beep when this option is selected. Removing clothes and hanging them when they are damp can reduce the need to iron some items. Signal Alerts you that the cycle is complete. The beeper will continue to sound every two minutes for the next 6 minutes, until the clothes have been removed. The clothes should be removed when the beeper goes off so wrinkles don't set in. Press SIGNAl to select low, medium or high volume, or to turn the beeper off. Delay Start (on some models) Use to delay the start of your dryer. 1. Choose your dry cycle and any options. 2. Press DElAy START. You can change the delay time in 1 hour increments using the + or - arrow pads. 3. Press the START pad to start the countdown. The countdown time will be shown in the ESTIMATED TIME REMAINING display. NOTES: n If the door is opened while the dryer is in DElAy, the countdown time will not restart unless the door is closed and START has been pressed again. n You can delay the start of a dry cycle up to 18 hours for models DCVH640, DCVH680, DHDVH68 and up to 10 hours for model DBVH520. Troubleshooting Tips Consumer Support 10