GE DCVH680EJWW Use and Care Manual - Page 14

Remove Hinge, Reinstall Hinge Assembly

Get GE DCVH680EJWW - 7.0 cu.ft. Electric Dryer PDF manuals and user guides
UPC - 084691177166
View all GE DCVH680EJWW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Safety Instructions Operating Instructions GEAppliances.com STEP-BY-STEP INSTRUCTIONS (cont.) Remove Hinge IMPORTANT: Note the location of the hinge (left or right) before removing. 8.With the door frame part of the door laid down on a protected soft surface, remove the hinge cover by removing the 2 tapping screws (#8) that fasten it to the frame. The hinge cover is located at the opposite side of the hinge assembly. 9.Remove the 2 nuts, washers and the 2 machine screws (#8). 10.Remove the hinge assembly by removing the 2 machine screws (#8) that fasten it to the frame. Pull the hinge assembly out and set it aside. Reinstall Hinge Assembly 11. Place the hinge assembly in the opposite side of the door. Align the hinge holes with the door holes. 12. Loosely fasten the hinge assembly to the edge using 2 machine screws (#8). 13. Hold the door on its side with one hand and fasten the remaining 2 screws as shown. Then tighten the 2 screws (#8) holding the hinge assembly. 14 Troubleshooting Tips Consumer Support

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
14
Consumer Support
Troubleshooting Tips
Operating Instructions
Safety Instructions
GEAppliances.com
STEP-BY-STEP INSTRUCTIONS (cont.)
Remove Hinge
IMPORTANT:
Note the location of the hinge (left or right) before removing.
8.
With the door frame part of the door laid down on a protected soft surface,
remove the hinge cover by removing the 2 tapping screws (#8) that fasten
it to the frame. The hinge cover is located at the opposite side of the hinge
assembly.
9.
Remove the 2 nuts, washers and the 2 machine screws (#8).
10.
Remove the hinge assembly by removing the 2 machine screws (#8) that
fasten it to the frame. Pull the hinge assembly out and set it aside.
Reinstall Hinge Assembly
11.
Place the hinge assembly in the opposite side of the door. Align the hinge
holes with the door holes.
12.
Loosely fasten the hinge assembly to the edge using 2 machine screws (#8).
13.
Hold the door on its side with one hand and fasten the remaining 2 screws as
shown. Then tighten the 2 screws (#8) holding the hinge assembly.