GE DPSR610GGWT Owners Manual - Page 13
Troubleshooting Tips - review
UPC - 084691138983
View all GE DPSR610GGWT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Safety Instructions Operating Instructions Before you call for service... Troubleshooting Tips Save time and money! Review the charts on the following pages, or visit ge.com. You may not need to call for service. ge.com Problem Dryer doesn't start Dryer doesn't heat Dryer shakes or makes noise Greasy spots on clothes Lint on clothes Static occurs Inconsistent drying times Possible Causes Dryer is unplugged Fuse is blown/circuit breaker is tripped What To Do • Make sure the dryer plug is pushed completely into the outlet. • Check the house fuse/circuit breaker box and replace fuse or reset breaker. NOTE: Most electric dryers use two fuses/breakers. Fuse is blown/circuit breaker is tripped; the dryer may tumble but not heat Gas service is off No heat temperature selected • Check the house fuse/circuit breaker box and replace both fuses or reset both breakers. Your dryer may tumble if only one fuse is blown or one breaker is tripped. • Make sure gas shutoff at dryer and main shutoff are fully open. • Select another heat setting. Some shaking/noise is normal. • Move dryer to an even floor space, or adjust leveling legs Dryer may be sitting unevenly as necessary until even. Improper use of fabric softener Drying dirty items with clean ones Clothes were not completely clean • Follow directions on fabric softener package. • Use your dryer to dry only clean items. Dirty items can stain clean items and the dryer. • Sometimes stains which cannot be seen when the clothes are wet appear after drying. Use proper washing procedures before drying. Lint filter is full • Clean lint screen before each load. Improper sorting • Sort lint producers (like chenille) from lint collectors (like corduroy). Static electricity can attract lint • See suggestions in this section under STATIC. Overloading • Separate large loads into smaller ones. Paper, tissue, etc., left in pockets • Empty all pockets before laundering clothes. No fabric softener was used Overdrying Synthetics, permanent press and blends can cause static • Try a fabric softener. • Bounce® Fabric Conditioner Dryer Sheets have been approved for use in all GE Dryers when used in accordance with the manufacturer's instructions. • Try a fabric softener. • Adjust setting to LESS DRY or DAMP DRY. • Try a fabric softener. Type of heat • Automatic drying times will vary according to the type of heat used (electric, natural or LP gas), size of load, types of fabrics, wetness of clothes and condition of exhaust ducts. Troubleshooting Tips Consumer Support 13