GE GAS18PSJSS Installation Instructions - Page 6

About the AutoFill pitcher - water filter

Get GE GAS18PSJSS PDF manuals and user guides View all GE GAS18PSJSS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

About the AutoFill pitcher (on some models). WARNING To reduce the risk associated with choking, do not allow children less than 3 years of age to have access to small parts during the installation of this product. 7KH$XWR)LOOSLWFKHULVGHVLJQHGIRUKDQGVIUHHUH¿OOLQJRIWKH pitcher for a constant supply of fresh water. The refrigerator shelf must be at the second position to use the AutoFill pitcher. 1. Place the lid onto the pitcher so it fits securely. Align the notch in the pitcher lid to the dispenser guide in the top of the refrigerator and slide the pitcher toward the back of the refrigerator until it stops. Dispenser guide 2. Water will fill the pitcher until it reaches a specified level and will then shut off. NOTE: If you remove the pitcher before the water stops, water may drip on the shelf. When you replace the pitcher back under the dispenser, it will refill the pitcher back to the specified level. Notch in top of pitcher Shelf at second position The Water Filter is located on the underside of the dispenser KRXVLQJ7KH¿OWHUVKRXOGEHUHSODFHGHYHU\VL[PRQWKVRULI WKHÀRZRIZDWHUGHFUHDVHV

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
6
About the AutoFill pitcher
(on some models)
.
The Water Filter
is located on the underside of the dispenser
the bypass plug in place when using the AutoFill Pitcher.
To remove
holder.
DO NOT TWIST THE FILTER.
To replace
bypass plug straight into the opening and continue to push as
check to ensure it is properly aligned and fully seated into the
holder.
cause water to drip from the dispenser.
(about 5 minutes) to remove air from the system.
NOTE:
It is normal for water to appear discolored during the
Reset
Filter Change
button for 3 seconds. The
Filter Status.
or call GE Parts and Accessories at
800.626.2002
.
pitcher for a constant supply of fresh water. The refrigerator
shelf must be at the second position to use the AutoFill pitcher.
1.
Place the lid onto the pitcher so it fits securely. Align the
notch in the pitcher lid to the dispenser guide in the top of
the refrigerator and slide the pitcher toward the back of
the refrigerator until it stops.
2.
Water will fill the pitcher until it reaches a specified level and
will then shut off.
NOTE:
If you remove the pitcher before the water stops,
water may drip on the shelf.
When you replace the pitcher back under the dispenser, it
will refill the pitcher back to the specified level.
WARNING
To reduce the risk associated with choking, do not allow children less than 3 years of age to have access
to small parts during the installation of this product.
Press and
hold to reset
water filter
status
1
2
45°
Holds water
filter or bypass
plug in place
Water filter or
bypass plug holder
1
2
1
Water filter
snaps into
place
Water filter or
bypass plug
holder
Key
(both sides)
Key slots
Notch in top
of pitcher
Dispenser guide
Shelf at second
position