GE GDT695SMJES Installation Instructions - Page 7

Dishwasher Installation STEP 5: IF NECESSARY, REMOVE FLOOR PROTECT PAN (on some models) • Disconnect leak sensor wire (on some models). Squeeze connector at top to release snap feature • Pull floor protect pan forward and slide it from under the dishwasher. • Set aside for use in Step 21. STEP 8: POSITION WATER LINE AND HOUSE WIRING • Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher. Leak Sensor 4" 4" 6" 6" Water House Line Wiring Floor Protect Pan Figure L STEP 6: INSTALL 90° ELBOW • Thread 90° elbow onto the water valve. Ensure rubber gasket is located between valve and elbow. Water Valve Bracket • Do not overtighten elbow. Water valve bracket could bend or water valve fitting could break. • Position the end of the elbow to face the rear of the dishwasher. Figure M Front of dishwasher 90° Elbow Fill Hose STEP 7: INSTALL DRAIN HOSE TO DRAIN LOOP Connect drain loop end to drain hose using the screw clamp as shown in the figure. Figure N NOTE: The high drain loop on the side of the tub is designed for better wash performance. Do not remove from the side of the tub. Figure O STEP 9: INSTALL DRAIN HOSE, THROUGH CABINET • Position dishwasher in front of cabinet opening. Insert drain hose into the hole in cabinet side. If a power cord is used, guide the end through a separate cabinet opening. Insulation Blanket House Wiring Power Cord (If used) Water Line Drain Hose Ensure drain hose is not twisted or pinched Maximum drain hose length is 15' Do not disconnect or remove high drain loop from left side of dishwasher Figure P 7LS3UHYHQWXQQHFHVVDU\VHUYLFHFDOOFKDUJHVIRU¿OOGUDLQ or noise concerns. Position utility lines so they do not interfere with anything under or behind the dishwasher. 7