GE GG50T06PVK Use and Care Manual - Page 18
Insulation Blankets
View all GE GG50T06PVK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Operating Instructions Installation Instructions Safety Instructions Installing the water heater. WARNING: If local codes require external application of insulation blanket kits the manufacturer's instructions included with the kit must be carefully followed. Insulation Blankets Insulation blankets, available to the general public, for external use on gas water heaters are not necessary. The purpose of an insulation blanket is to reduce the standby heat loss encountered with storage tank heaters. This water heater meets or exceeds the National Appliance Energy Conservation Act standards with respect to insulation and standby loss requirements making an insulation blanket unnecessary. The manufacturer's warranty does not cover any damage or defect caused by installation, attachment or use of any type of energy saving or other unapproved devices (other than those authorized by the manufacturer) into, onto or in conjunction with the water heater. The use of unauthorized energy saving devices may shorten the life of the water heater and may endanger life and property. The manufacturer disclaims any responsibility for such loss or injury resulting from the use of such unauthorized devices. CAUTION: If local codes require the application of an external insulation blanket to this water heater, pay careful attention to the following so as not to restrict the proper function and operation of the water heater: ● Do not cover the operating or warning labels attached to the water heater or attempt to relocate them on the exterior of insulation blanket. Do not apply insulation to the top of the water heater. This will interfere with the safe operation of the blower assembly. Do not cover the burner access door, jacket door, gas control (thermostat)/gas valve or pressure and temperature relief valve. Do not apply insulation to the bottom of the water heater or the area where the combustion air inlet openings and Flammable Vapor Sensor are located. This area must be unobstructed so as not to restrict combustion air flow to the burner or operation of the sensor. Inspect the insulation blanket frequently making certain it has not sagged and it is not restricting the air flow to the combustion air inlet openings (perforation holes) or the Flammable Vapor sensor located around the lower perimeter of the water heater jacket. This could result in an unsafe operating condition. Care and Cleaning Troubleshooting Tips Customer Service 18