GE GPE12FGKBB Use and Care Manual - Page 8

Installation, Refrigerator, Instructions - model

Page 8 highlights

Installation Instructions Refrigerator Model GPE12 If you have questions, call GE Appliances at 1.800.GE.CARES or visit our Website at: GEAppliances.com. In Canada, call 1.800.561.3344 or Visit our Website at: www.geappliances.ca. BEFORE YOU BEGIN Read these instructions completely and carefully. IMPORTANT - • Save these instructions for local inspector's use. IMPORTANT - • Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Skill level - Installation of this appliance requires basic mechanical skills. • Completion time - Refrigerator Installation -15 minutes Reversing the Door Swing - 1 hour • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. LOCATION REQUIREMENTS • Do not install the refrigerator where the temperature will go below 60°F (16°C) because it will not run often enough to maintain proper temperatures. • Do not install the refrigerator where the temperature will go above 100°F (37°C) because it will not perform properly. • Do not install the refrigerator in a location exposed to water (rain, etc.) or direct sunlight. • Install it on a floor strong enough to support it fully loaded. UNPACKING YOUR REFRIGERATOR • Remove tape and any labels (except for the rating label) from your refrigerator. Tape or glue residue can also be removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry. • Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. • When moving the refrigerator, do not tilt the refrigerator beyond 45° from upright position. LEVELING LEGS Adjustable legs at the front corners of the refrigerator should be set so the refrigerator is firmly positioned on the floor, and the front is raised just enough that the door closes easily when opened about halfway. To adjust the leveling legs, turn the legs clockwise to raise the refrigerator, counterclockwise to lower it. To raise the refrigerator CLEARANCES • Free-standing installation only. • If the refrigerator is being installed next to a wall, leave sufficient space on the hinge side to allow the door to swing open enough to access the clear bins in the refrigerator compartment. • Do not install within 5" (13 cm) of the range. • Minimum Clearances: Back - 3" from the wall POWER CORD • Plug the refrigerator power cord into its own properly grounded wall outlet with a voltage rating matching that on the refrigerator rating plate. • Do not use an extension cord. • Read all safety precautions on pages 2 and 3. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

Installation
Refrigerator
Instructions
Model GPE12
LEVELING LEGS
Adjustable legs
at the front corners of the refrigerator
should be set so the refrigerator is firmly positioned
on the floor, and the front is raised just enough that
the door closes easily when opened about halfway.
To adjust the leveling legs,
turn the legs
clockwise
to raise
the refrigerator,
counterclockwise to lower
it.
If you have questions, call GE Appliances at 1.800.GE.CARES
or
visit our Website at:
GEAppliances.com.
In Canada, call 1.800.561.3344
or
Visit our Website at:
www.geappliances.ca.
To raise the refrigerator
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
Save these instructions for local
inspector’s use.
IMPORTANT –
Observe all governing codes
and ordinances.
Note to Installer –
Be sure to leave these instructions
with the Consumer.
Note to Consumer –
Keep these instructions
for future reference.
Skill level – Installation of this appliance requires basic
mechanical skills.
• Completion time –
Refrigerator Installation -15 minutes
Reversing the Door Swing - 1 hour
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered
under the Warranty.
LOCATION REQUIREMENTS
Do not install the refrigerator where the temperature will
go below 60°F (16°C) because it will not run often enough
to maintain proper temperatures.
Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not perform
properly.
Do not install the refrigerator in a location exposed to water
(rain, etc.) or direct sunlight.
Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Free-standing installation only.
If the refrigerator is being installed next to a wall, leave
sufficient space on the hinge side to allow the door
to swing open enough to access the clear bins in the
refrigerator compartment.
Do not install within 5” (13 cm) of the range.
Minimum Clearances:
Back – 3” from the wall
UNPACKING YOUR REFRIGERATOR
Remove tape and any labels (except for the rating label)
from your refrigerator. Tape or glue residue can also be
removed by rubbing a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm
water and dry.
Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove tape
or glue. These products can damage the surface of your
refrigerator.
When moving the refrigerator, do not tilt the refrigerator
beyond 45° from upright position.
POWER CORD
Plug the refrigerator power cord into its own properly
grounded wall outlet with a voltage rating matching that
on the refrigerator rating plate.
Do not use an extension cord.
Read all safety precautions on pages 2 and 3.
8